replacing ball joints - easy job????
Discussion
Yes, I've done it on my S1 111s and now on my S1 Sport 160. The easiest way to do it is to remove the offending wishbone complete ... just undo the inner suspension bolts and slide them out. Thus remove the wishbone and take, with new vauxhall ball joint, to any garage (check first). The one I use charges me a pint per joint. With the joint at about £17 it's a whole lot cheaper that taking it to a dealer. HTH
As for steps, here goes:
1 remove roadwheel
2 remove steel plinth from ally hub carrier, bottom ones are 4 bolts, tops are 2 hex studs (if tops save the spacers carefully)
3 remove 2 inner wishbone pivot bolts and withdraw
4 withdraw wishbone making sure brake hose is not put under stress when wb removed
5 take wishbone and balljoint to a garage
6 re-assemble in reverse procedure. Note that you should use the yellow anti-corrosion paint on all ally to steel joints, and locking compound on all bolts that go into ally. I have found, however, that so long as you torque up the bolts correctly (45nm IIR) they will not move even without the locking compound.
If you have a suitable mobile press then you could do this without removing the wishbone.
As for steps, here goes:
1 remove roadwheel
2 remove steel plinth from ally hub carrier, bottom ones are 4 bolts, tops are 2 hex studs (if tops save the spacers carefully)
3 remove 2 inner wishbone pivot bolts and withdraw
4 withdraw wishbone making sure brake hose is not put under stress when wb removed
5 take wishbone and balljoint to a garage
6 re-assemble in reverse procedure. Note that you should use the yellow anti-corrosion paint on all ally to steel joints, and locking compound on all bolts that go into ally. I have found, however, that so long as you torque up the bolts correctly (45nm IIR) they will not move even without the locking compound.
If you have a suitable mobile press then you could do this without removing the wishbone.
Edited by stevie111s on Wednesday 20th June 13:13
Edited by stevie111s on Wednesday 20th June 13:16
The elise parts ball joint tool is great and very easy to use. The Elise parts balljoints fit nicely too. I too removed the wishbones to do it but then I was replacing the bushes with Nylatrons at the time. It looks possible to do it in situ and certainly worth trying as if you find it too fiddly you'd have already removed what you have to remove to take the wishbone off anyway if you see what I mean.
I notice you are 'South.' If you're anywhere near Gosport you are welcome to borrow my ball joint tool if you like.
I notice you are 'South.' If you're anywhere near Gosport you are welcome to borrow my ball joint tool if you like.
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff



