Getting some work done - any idea what it'll cost?
Discussion
Hi all, wet weekend so no fun with the car 
Anyway, my Elise is booked into Horizon in a couple of weeks for some work and I was just wondering what it's likely to cost me. This is what they're going to look at:
1) Getting the creaking from the rear suspension fixed - it only happens on the drivers side when the car's warm so I'm thinking it'll be one of the toelinks. Dunno whether it's going to be a replace or re-greese job, if indeed that's the problem.
2) Dodgy temp sender fixed - every now and again the temp on the stack just disappears and the engine starts to 'hunt' at idle. The temp will then mysteriously reappear at normal operating temp (84 degs) so I think it's probably a sensor problem.
3) I've asked them to give me a quote for a respray of the lower half of the front clam to get rid of lots of stone chips, as well as both sills which are looking a bit rough now. I'm also interested in getting the front and the sills 'armourfended' to prevent this happening again.
4) Finally, I need a little bit of fibreglass work done on a couple of chips on the passenger door, as well as a small crack just at the bottom of the number plate plinth (above where the splitter fits) - I think a speed bump caused this!
So, quite a few bits and bobs - the resprays and armourfend will cost the most I suspect, but any ideas what the lot will set me back. I'm expecting no change from a grand!
Thanks

Anyway, my Elise is booked into Horizon in a couple of weeks for some work and I was just wondering what it's likely to cost me. This is what they're going to look at:
1) Getting the creaking from the rear suspension fixed - it only happens on the drivers side when the car's warm so I'm thinking it'll be one of the toelinks. Dunno whether it's going to be a replace or re-greese job, if indeed that's the problem.
2) Dodgy temp sender fixed - every now and again the temp on the stack just disappears and the engine starts to 'hunt' at idle. The temp will then mysteriously reappear at normal operating temp (84 degs) so I think it's probably a sensor problem.
3) I've asked them to give me a quote for a respray of the lower half of the front clam to get rid of lots of stone chips, as well as both sills which are looking a bit rough now. I'm also interested in getting the front and the sills 'armourfended' to prevent this happening again.
4) Finally, I need a little bit of fibreglass work done on a couple of chips on the passenger door, as well as a small crack just at the bottom of the number plate plinth (above where the splitter fits) - I think a speed bump caused this!
So, quite a few bits and bobs - the resprays and armourfend will cost the most I suspect, but any ideas what the lot will set me back. I'm expecting no change from a grand!
Thanks
Replacing of rear toelinks with OEM ones including a Geo-setup afterwards; I have just been quoted approx £300 from a specialist. If you go for the Uniball ones (which are the upgraded ones and don't creak), add another £220 on top. For regreasing - I guess a lot less than this. I had this problem and regreassing seemed to work.
As for bodywork repair - hard to say without seeing damage and amount of repair required.
Temp sender is around £15, just need to add the labour - shouldn't take that long.
Respray of front clam below badge / swage line is about £400 I think, Sills are I think prob around £200 but that a bit of a guess as I have never asked for a quote for that and maybe cheaper if you getting both done at same time.
Armourfend is about £500 fitted for area you want last time I looked.
HTH - should give you a basic idea. This is what I have worked out from all of the work / estimates I have had to have. You may be able to get it cheaper / more expensive....
As for bodywork repair - hard to say without seeing damage and amount of repair required.
Temp sender is around £15, just need to add the labour - shouldn't take that long.
Respray of front clam below badge / swage line is about £400 I think, Sills are I think prob around £200 but that a bit of a guess as I have never asked for a quote for that and maybe cheaper if you getting both done at same time.
Armourfend is about £500 fitted for area you want last time I looked.
HTH - should give you a basic idea. This is what I have worked out from all of the work / estimates I have had to have. You may be able to get it cheaper / more expensive....
Edited by darren_S2 on Sunday 24th June 17:30
Thanks for the reply - very informative!
If it is the toelink that's the issue then it will have to be replaced as I can stand the noise and there's a big toelink-related scare thread going around seloc at the mo so it's not worth taking a chance. As for the uniball ones - hmmm, not sure about them. They're a lot more but is it worth oem replacements going the same way as the old ones a year or two down the line? Dunno...
Temp sender sounds cheepo which is good!
Respray is about what I figured, hopefully the sills wont cost that much. £500 for armourfend!? bloody hell, that's a lot for a bit of shrink-wrap
Are there any cheaper alternatives that do the job but don't rely on the name? Again, I suppose it's the fitting-labour for a precise job that bumps up the cost. Shame, as it's not worth getting the resprays without some way of protecting the work.
Looks like I'll have to bump my budget up a little but it's worth it in the long run for resale value if I ever lose my mind and flog the Liz!
If it is the toelink that's the issue then it will have to be replaced as I can stand the noise and there's a big toelink-related scare thread going around seloc at the mo so it's not worth taking a chance. As for the uniball ones - hmmm, not sure about them. They're a lot more but is it worth oem replacements going the same way as the old ones a year or two down the line? Dunno...
Temp sender sounds cheepo which is good!
Respray is about what I figured, hopefully the sills wont cost that much. £500 for armourfend!? bloody hell, that's a lot for a bit of shrink-wrap
Are there any cheaper alternatives that do the job but don't rely on the name? Again, I suppose it's the fitting-labour for a precise job that bumps up the cost. Shame, as it's not worth getting the resprays without some way of protecting the work. Looks like I'll have to bump my budget up a little but it's worth it in the long run for resale value if I ever lose my mind and flog the Liz!
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff






