Diff and gear oil
Discussion
Lee,
I think on the rover box you undo the filler nut and stick a bent wire down inside the gear box and see how far up the wire it goes if you get my drift.
To fill to correct level, use a squeezy bottle with a pipe on and fill to over flowing then allow the fluid to drain to bottom filler hole.
The same applies to the diff but make sure you use LSD oil not gear box oil.
Hope this helps.
Paul.
I think on the rover box you undo the filler nut and stick a bent wire down inside the gear box and see how far up the wire it goes if you get my drift.
To fill to correct level, use a squeezy bottle with a pipe on and fill to over flowing then allow the fluid to drain to bottom filler hole.
The same applies to the diff but make sure you use LSD oil not gear box oil.
Hope this helps.
Paul.
leetvr said:
Hi lee,
Why don't you take it to my local garage he's just replaced both oils in mine did'nt charge much neither.
Pain in the arse doing it yourself IMO.
Regards
V8 Animal
Hi, where did u take it and what did he charge?Why don't you take it to my local garage he's just replaced both oils in mine did'nt charge much neither.
Pain in the arse doing it yourself IMO.
Regards
V8 Animal
we need a local meet soon, if it stops raining
Yeah your right.
Longbridge Autos
Ascot Drive Ind Est
Robbie is the man.
As for price it's at work so post tommorow.
Cheers mate.
leetvr
spend said:
Barreti said:
clarkeyjnr said:
leetvr said:
How do i check them? its on a 94 400, GKN diff, rover SD1 gearbox.
Thanks
leetvr
You could always try opening the bonnet for starter....? Thanks
leetvr



Dave
Jack it up and crawl under...gives you a good excuse to check the chassis at the same time!!!
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



