Clutch - High biting point
Clutch - High biting point
Author
Discussion

evomike

Original Poster:

45 posts

266 months

Saturday 30th June 2007
quotequote all
Hi guys,

A quick question. My girlfriend has noticed that the clutch biting point in her Elise (S2, 120bhp K-series) seems to have recently become much higher. I had a quick drive and it definately seems to be biting much nearer to the top of the travel. Also, you can notice a change in sound as you depress the clutch when in neutral. Now this may be normal but not being used to a car where the engine is right behind your head it is not something I've ever noticed before.

Does anyone have any ideas? If it needs a new clutch, how much is replacement likely to cost?

Cheers

Mike

Sam_68

9,939 posts

276 months

Saturday 30th June 2007
quotequote all
The change in noise when you depress the clutch in neutral is normal.

Explanation:
When the clutch is engaged in neutral, the gearbox input shaft and all gears are spinning, they're just not connected to the output shaft, so you can hear the whine of the gears meshing. If you depress the clutch pedal, the gearbox is disconnected from the engine and will slow to a halt, so the whining noise of the meshing gears should disappear. This is the same on all cars with manual gearboxes - just that you can hear everything very clearly on an Elise due to the chassis construction.

If, however, you get a pronounced screech/whine when you push the clutch pedal down, then the clutch thrust bearing is on its way out.

The high biting point could be a hydraulic problem; either the clutch fluid needs bleeding or, if the car is a series 1 still fitted with the dreaded red clutch hose, then the hose might have got a bit soft and flexible with heat.

The other thing that would cause it, though - and another known fault on the K-series Elise - is that the mounting bracket for the slave cylinder might have bent.

Either way, provided it isn't slipping or juddering, the chances are that the clutch itself is fine. Bleeding the fluid or replacing the slave cylinder mounting bracket are both cheap, easy jobs. Replacing a red clutch hose with a braided steel one is a bit of a pain in the ass, so is likely to cost you £200-£300 in labour, plus the cost of the new hose (£60, at a guess?) if you get a garage to do it.

Edited to add: if your girlfriend's car is a Series 2, it should have the braided steel hose as standard. First things to do would be to bleed the fluid and check the slave cylinder mounting bracked, therefore. Neither will break the bank. wink

Edited by Sam_68 on Saturday 30th June 19:58

evomike

Original Poster:

45 posts

266 months

Sunday 1st July 2007
quotequote all
Thanks very much. She'll be very happy to hear that!!!

Mike