Braided lines - 15mm?
Braided lines - 15mm?
Author
Discussion

21TonyK

Original Poster:

13,403 posts

240 months

Monday 2nd July 2007
quotequote all
Back on the brakes again so to speak. Until now I have been put off braided lines by having no definite answer as to whether the benefits justify the PITA fitting on an S2 Exige.

Having look at the issue I believe the only problem fitting in the offside front where the chassis end of the line is obscured by the ABS unit. I'm now pretty sure that by using a slightly modified box spanner I can fit the line without removing the front clam which makes it worth a go.

Question is, are the fittings on braided lines 15mm, the same as OEM? I'd imagine they're all the same but can anyone confirms this?


Stonie

140 posts

253 months

Monday 2nd July 2007
quotequote all
Geary of eliseparts is aware of this very issue with the offside braided hose rubbing against the ABS bracket following instalation, after being informed by myself while fitting his braided hoses last week. I've requested a 60mm longer hose from him to resolve this issue, which is in the post as I write this. Geary will then be receiving feedback from me about this new longer hose.

I don't know about the Exige, but I've NOT had to remove the front clam on my Elise to fit these hoses. You will need 13, 15 & 17mm open ended spanners to remove the rubber hoses & 13, 14 & 17mm open ended spanners to fit the new braided hoses... Geary's hoses that is.

One tip, the supplied nuts with the braided hoses are zinc plated. I've replaced mine with stainless ones to match the rest of the stainless fittings. Thread size is M10x1.0mm. I've also used stainless 10mm washers and stainless 10mm internal shakeproof washers throughout.

Hope this helps.

21TonyK

Original Poster:

13,403 posts

240 months

Monday 2nd July 2007
quotequote all
Stonie said:
Geary of eliseparts is aware of this very issue with the offside braided hose rubbing against the ABS bracket following instalation, after being informed by myself while fitting his braided hoses last week. I've requested a 60mm longer hose from him to resolve this issue, which is in the post as I write this. Geary will then be receiving feedback from me about this new longer hose.

I don't know about the Exige, but I've NOT had to remove the front clam on my Elise to fit these hoses. You will need 13, 15 & 17mm open ended spanners to remove the rubber hoses & 13, 14 & 17mm open ended spanners to fit the new braided hoses... Geary's hoses that is.

One tip, the supplied nuts with the braided hoses are zinc plated. I've replaced mine with stainless ones to match the rest of the stainless fittings. Thread size is M10x1.0mm. I've also used stainless 10mm washers and stainless 10mm internal shakeproof washers throughout.

Hope this helps.
Sounds good. Geary has posted on another forum saying they now supply longer hoses for ABS cars so sounds like it could be a way forward.

Cheers