Replacing Temp Senders Elise S1
Replacing Temp Senders Elise S1
Author
Discussion

jjwprestidge

Original Poster:

36 posts

234 months

Tuesday 10th July 2007
quotequote all
Please can someone explain in simple terms how to replace the 2 temp senders on an S1 Elise. I assume this is fairly easy.

Thanks.

JP

porteouz

123 posts

235 months

Wednesday 11th July 2007
quotequote all
Pull out the little retaining clip. Pull out the senser. Put new one on plug and reverse the process. Sounds easy, its a nightmare. Unless you are 4 inches tall and can climb in the engine bay its a censored of a job. And dont drop the little clips either or you wont see it again

stevie111s

123 posts

266 months

Wednesday 11th July 2007
quotequote all
not difficult but you need to be quick when you unscrew them so you don't lose too much coolant (and obviously don't do it when the coolant is hot!) Why do you need to replace both though? One is for the Stack, the other for the ECU ... are you sure they are both US? They are quite easy to check with a multi-meter set to ohms, I can give you the readings at various rough temperatures if you wish. HTH

jjwprestidge

Original Poster:

36 posts

234 months

Wednesday 11th July 2007
quotequote all
OK - thanks. Am getting strange readings from the Stack, so I think it's probably only the one that needs replacing.

JP