2004 S2 Lotus Elise 111S Engine
2004 S2 Lotus Elise 111S Engine
Author
Discussion

gregbarton

Original Poster:

1 posts

232 months

Thursday 12th July 2007
quotequote all
I have got hold of a 1.8VVC engine, gearbox and wiring loom from a 2004 S2 Lotus Elise 111S!

However it came without the ECU as it was from a honda conversion and the ECU was remapped to the honda engine, and I am intending to use it in a kit car!

I am planning to get another S2 Lotus K4 ECU so I can use the exsisting wiring loom but I am unsure about any immobiliser or alarm features the ECU may have!?

Will I be able to just connect up and use any other 2nd hand S2 Lotus K4 ECU with it without having any problems with any built in immobiliser system as I will probably install a aftermarket immobiliser/alarm system when the car is built!?

Im asking this as I am more familiar with the Rover ECU's which need the correctly aligned 5AS system to operate correctly and the Lotus ECU is a hybrid of the Rover ECU! But i would prefer to use the exsisting loom and get a Lotus ECU than to get a new loom, rover ecu and 5as system!

Any help would be great as im not sure what to do next!

shangani

3,069 posts

268 months

Thursday 12th July 2007
quotequote all
Welcome to PH. AFAIK the rover ECU cannot be remapped to run the honda - the honda ECU is used and remapped. You could always get an emerald and future proof the car for upgrades.

kambites

71,703 posts

252 months

Thursday 12th July 2007
quotequote all
I hope you're aware that your car may well sound like a tractor at idle when you've fitted the VVC engine, mine does. Goes well though biggrin

Lotusnick S2

251 posts

261 months

Thursday 12th July 2007
quotequote all
If it helps, I have tested another S2 111s ECU on my car for a friend.
The car started and worked fine, but the MIL light was on.

So I guess there shouldn't be an issue with the alarm wink

Honda conversions on the S2, use the Lotus ECU just to drive the speedo on the Stack not run the engine.

Poltergeist_666

90 posts

236 months

Thursday 12th July 2007
quotequote all
kambites said:
I hope you're aware that your car may well sound like a tractor at idle when you've fitted the VVC engine, mine does. Goes well though biggrin
The engine that Greg has bought, is my old one. It never sounded like a tractor, while it was fitted in my car.

On the subject of ECU's - does anyone know where the original is located in a S2 111S. I need to take a look, to be able to take some piccys.

Cheers in advance.

Edited by Poltergeist_666 on Thursday 12th July 17:55

Lotusnick S2

251 posts

261 months

Thursday 12th July 2007
quotequote all
Poltergeist_666 said:
kambites said:
I hope you're aware that your car may well sound like a tractor at idle when you've fitted the VVC engine, mine does. Goes well though biggrin
The engine that Greg has bought, is my old one. It never sounded like a tractor, while it was fitted in my car.

On the subject of ECU's - does anyone know where the original is located in a S2 111S. I need to take a look, to be able to take some piccys.

Cheers in advance.

Edited by Poltergeist_666 on Thursday 12th July 17:55
I think he meant the diesel-y sound of the VVC engine on idle.
Good fresh oil, makes it a bit quiter.

The ECU is stuck on the rear clam, next to the throttle body, under a plastic cover. (if it makes sense)

Poltergeist_666

90 posts

236 months

Thursday 12th July 2007
quotequote all
Mine must have been a sweet idling K!

Cheers Nick - I'll go take a look, and see what I can find .....

kambites

71,703 posts

252 months

Friday 13th July 2007
quotequote all
From what I could find out, some VVCs sound very rattly at idle and some are quite smooth. Neither Rover nor Lotus understand why or can do anything about it. I seem to have a particular noisy one but Sportomotive had a listen and said there was nothing wrong with it.

Ben Cole

24 posts

276 months

Monday 16th July 2007
quotequote all
I agree. My old VVC Coupe was quite smooth sounding but I heard plenty of "tractors"