inlet manifold
Discussion
can anyone tell me the hole sizes in the inlet manifold where the trumpet base bolts to the manifold itself,I think its 44mm diam,but need to be certain,mainly for 500 but also sizes, if different, for the 4ltr and 4.3.
thanks in advance
clive
thanks in advance
clive
Edited by clive f on Tuesday 17th July 14:01
clive f said:
can anyone tell me the hole sizes in the inlet manifold where the trumpet base bolts to the manifold itself,I think its 44mm diam,but need to be certain,mainly for 500 but also sizes, if different, for the 4ltr and 4.3.
thanks in advance
clive
Pretty sure it is 38mm standard, and if they are enlarged then its too 45mm.thanks in advance
clive
Edited by clive f on Tuesday 17th July 14:01
If you need any I have a couple of hotwire ones here looking for something to do.
It will depend on how early/late the car was made.Many earlier 5 litre cars had the ports opened out to 44/45mm at the factory(still with the awfull 'exhaust tube' unflared trumpets though),whereas later cars were 38mm and left unported,wheather this coincides with the 'hc' badge being removed i'm not sure

Meatball said:
ahhhh that would be my old one 
typical , popped up just after I recieved mine from Rangeroverheaven.
clive f said:
nope, but you `ll want one when you see it!
Go on tease me, by mail if you like.
As I said if you want one to play with I have two here.
Edited by AntonyJ on Tuesday 17th July 20:25
Edited by AntonyJ on Tuesday 17th July 20:27
Gassing Station | Griffith | Top of Page | What's New | My Stuff


