Clutch and quick shift question
Clutch and quick shift question
Author
Discussion

Dr Bunsen

Original Poster:

57 posts

233 months

Thursday 19th July 2007
quotequote all
Hello All

I am a newbee and a bit of advise would be gratefully recieved.

My S2 (k series) clutch is not a happy bunny and needs replacing, i have heard that the AP kit is the way to go but is it worth the extra ££££ ?.
Second - is the quick shift kit worth getting (moto build)? i am a bit suspicious that they are a bit of gimmick and won't really improve the shift quality.
Third (and final) - are there any good independant garages in the chester/wirral area, i normally go to Christopher Neils and have excelent service but a job like this may be more suited to a good indy garage.

Look forward to any helpfull suggestions

thanks!

S Works

10,166 posts

281 months

Thursday 19th July 2007
quotequote all
AP clutches are better, and for the small increment in price it's probably not a bad thing.

Quick shift is OK, but the improved gear linkages from eliseparts or elise-shop are more worthwhile. Basically without the linkage, the quickshift's not really worth it IMO.

As for garage - SimonK and crackthatoff use an indie up near you, drop either of them a note via profile. Can't remember it's name at the moment. Pheonix?

NWTony

3,011 posts

259 months

Friday 20th July 2007
quotequote all
Phoenix are in Accrington, so a bit of a trip for you but your closest independent is Blink, which is right next door to Oulton park.

The shortshifter and improved linkage sets are available on E-bay.

RHY 11S

78 posts

248 months

Friday 20th July 2007
quotequote all
Might be worth replacing the Clutch Slave Cylinder (£approx35 + VAT) as I recently changed my clutch only to find the Slave Cylinder needed replacing as well - apparently the seals wear out quite easily, which can then let air into the clutch fluid and cause issues with your clutch. It shouldn't add much on to the labour costs if you get it done at same time.

Dr Bunsen

Original Poster:

57 posts

233 months

Friday 20th July 2007
quotequote all
Thanks very much guys. Ill give blink a try and will mention the master cylinder as well).

I've only recently found out about this forum and i think i've been missing out - i guess i've got a lot of catching up to do!

Thanks again!

R TOY

1,747 posts

259 months

Saturday 21st July 2007
quotequote all
We fitted a std clutch to our S1 and had big problems with clutch drag esp when hot. to the point that gear change was imposible. After changing everything else (master/slave cyl, braided hose. beefing up slave mount bracket) i reluctantly took the clutch out again and replaced with an AP unit from elise parts and clutch is now great. The other, cheaper clutch looked fine but wouldnt work. Took it back and got a refund but that didnt pay for the time and effort changing it. AP unit was about £150. Expensive but good!