(wireless?) networking question
Discussion
We've run into a little problem in the office - we're moving some machines into a previously unused room and can't get cat5 cable into it, at least not without taking up carpet, floorboards etc or drilling through a lot of walls.
So knowing very little about wireless I was wondering if there is some way to plug a wireless "something" into one of the hubs and have another wireless "something" in the new room connected to another hub and have those two devices act as a bridge to replace the difficult cable run. Trouble is I haven't the faintest idea what somethings would be needed.
Is this in any way feasible and if so, with what?
So knowing very little about wireless I was wondering if there is some way to plug a wireless "something" into one of the hubs and have another wireless "something" in the new room connected to another hub and have those two devices act as a bridge to replace the difficult cable run. Trouble is I haven't the faintest idea what somethings would be needed.
Is this in any way feasible and if so, with what?
K50 DEL said:
Would it not be easier just to have a wireless router in the existing office and stick a wireless card in each of the PC's to go into the unused section?
2 Macs, and 5 Windows machines, so lots of wireless cards would be ££££ which I know our boss won't like 
Current setup in the old office is an 8 port wired hub which each machine is connected to, so some kind of wireless hub/switch/bridge that could talk to another wireless hub/switch/bridge connected to the main network would be perfect

As Gateway says, 2x powerline adapters and a switch will work best. Alternativley if you own the building and it's not like 10 storys up... out one window in the other, then in to a switch.
I'd avoid Wireless, yes it's the simplest way, but it's also the most cumbersome as shooting through walls (especially ones made of brick and/or with pipes/cables in them) is a royal pain. It's also dog slow and can drop out, which will be nice... in the middle of a large Exchange/Outlook sync or similar.
I'd avoid Wireless, yes it's the simplest way, but it's also the most cumbersome as shooting through walls (especially ones made of brick and/or with pipes/cables in them) is a royal pain. It's also dog slow and can drop out, which will be nice... in the middle of a large Exchange/Outlook sync or similar.
Cheers chaps. Ended up getting a set of Netgear HDXB101 Powerline adapters:
http://www.ebuyer.com/UK/product/117384
Seem to be working fine after an initial problem where the pings to the server were taking up to 3 seconds(!) Solved by moving the adapters into different wall sockets
http://www.ebuyer.com/UK/product/117384
Seem to be working fine after an initial problem where the pings to the server were taking up to 3 seconds(!) Solved by moving the adapters into different wall sockets

Moose. said:
Cheers chaps. Ended up getting a set of Netgear HDXB101 Powerline adapters:
http://www.ebuyer.com/UK/product/117384
Seem to be working fine after an initial problem where the pings to the server were taking up to 3 seconds(!) Solved by moving the adapters into different wall sockets
I have to say I had this problem too and again moved the adapters to another plug socket and waheeeyyy. They may be a bit more costly than wireless but a rock solid connection and using the new AV standard I am getting between 60-85 Mbps, beat that with your wireless.http://www.ebuyer.com/UK/product/117384
Seem to be working fine after an initial problem where the pings to the server were taking up to 3 seconds(!) Solved by moving the adapters into different wall sockets

Gassing Station | Computers, Gadgets & Stuff | Top of Page | What's New | My Stuff



