Is it my CPU that is broke?
Author
Discussion

mcarrick69

Original Poster:

1,961 posts

259 months

Monday 23rd July 2007
quotequote all
How can I check that it is definately my CPU that is broke?

I've had my PC for about 6 month now, I built it myself, using a socket 939 AMD 3800+. I bought it boxed (rather than OEM) mainly for the Warenty and it came with a heatsink. since putting the heatsink on I thought it was rubbish. I'm constantly watching the CPU temp and it does occasionally get too hot (65 degrees) causing the PC to shut down.

Now I cannot get it to POST/monitor to come on. Although 1 in 10 times it will come on and start to load windows, then freeze whilst on the first progress bar. I've swapped memory about (2 modules) and changed graphics cards.
i dont have another socket 939 motherboard to try it with. Any ideas other than spend more money to find out I was wrong??

TIA

Road2Ruin

6,571 posts

247 months

Monday 23rd July 2007
quotequote all
Sounds like the heat sink wasnt making good contact with the chip. AMD chips are renowned for being cool (temperature not style) so 65C is way too much. If you are sure you fitted with heat sink correctly then I say return it and get another as I reckon its broke. However be prepared for them to tell you that you didnt fit the heat sink correctly or spread the paste enough, etc.

Jinx

12,023 posts

291 months

Monday 23rd July 2007
quotequote all
65 degrees isn't particular hot for a AMD 64 chip running at max voltage though on tick over it should be around 40 degrees (my AMD 64 laptop has been running at an average 75 degrees for the past 3 years at 1.5V). Maximum temp is round about 90 degrees.

ThePassenger

6,962 posts

266 months

Monday 23rd July 2007
quotequote all
Personally, I'd start poking around in the box before going after a dead CPU.

Pull all the RAM out and try turning it on. If it's still dead, remove everything else... you can even go as far as pulling the processor. Try powering on again.

If the bastid doesn't beep/scream blue murder for failing to initialise the CPU/RAM/GFX the mobo is dead. If it does and the last thing you removed is the processor... you've cooked it.


bobthemonkey

4,216 posts

247 months

Monday 23rd July 2007
quotequote all
Hate to state the obvious, but check the PSU.