Centre Consol Out
Discussion
If you have the early gear / door / brake all in the same leather gaiter:
There is only a single screw at the back, the front has 2 lohg pieces that slot into the transmission tunnel profile (where the chasss bolts & main earth are).
You need to slacken off the handbrake so it lifts up nearly vertical. Then slide the console back until the 'hooks' under the front tunnel sides are released. then it can be raised whilst jigling the handbrake. Shortening those protuberances a little makes it easier to refit & remove in the future.
Dave
There is only a single screw at the back, the front has 2 lohg pieces that slot into the transmission tunnel profile (where the chasss bolts & main earth are).
You need to slacken off the handbrake so it lifts up nearly vertical. Then slide the console back until the 'hooks' under the front tunnel sides are released. then it can be raised whilst jigling the handbrake. Shortening those protuberances a little makes it easier to refit & remove in the future.
Dave
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


