Stack speed settings
Discussion
Having fixed the wiring fault in the loom supplied by stack I can now put the sensor wiring back into the car.
Can someone save me the experimentation and tell me the circumference MM figure they have used for the Stack dash reading from the driveshaft on a GTR with standard factory wheels and tyres?
Thanks
Steve
Can someone save me the experimentation and tell me the circumference MM figure they have used for the Stack dash reading from the driveshaft on a GTR with standard factory wheels and tyres?
Thanks
Steve
I have just done mine, the factory instructed me to do it as follows.
1 place your car on a flat surface
2 Measure the distance of one full rotation of the wheel the sensor is fitted. - To do this place a mark on the very bottom tire, also place another mark on the floor, push the car forward until the wheel has done one full rotation and the mark is at the bottom closest to the floor again, place another mark on the floor.
3 Measure the distance between the two (in MM) and program that into the stack. My front wheel was 1923 MM also dont forget to set how many pulses per rotation the sensor counts.
hope this helps
John
>> Edited by J-K on Tuesday 3rd June 18:12
1 place your car on a flat surface
2 Measure the distance of one full rotation of the wheel the sensor is fitted. - To do this place a mark on the very bottom tire, also place another mark on the floor, push the car forward until the wheel has done one full rotation and the mark is at the bottom closest to the floor again, place another mark on the floor.
3 Measure the distance between the two (in MM) and program that into the stack. My front wheel was 1923 MM also dont forget to set how many pulses per rotation the sensor counts.
hope this helps
John
>> Edited by J-K on Tuesday 3rd June 18:12
Gassing Station | Ultima | Top of Page | What's New | My Stuff