"flat" clutch??
"flat" clutch??
Author
Discussion

davido140

Original Poster:

9,614 posts

255 months

Saturday 11th August 2007
quotequote all
Wasnt sure how to describe this, but Ive started to notice every so often the clutch is sort-of "flat" the pedal goes straight to the floor with virtually no resistance, I can take the car out of gear but cant put it into gear. if I let off the clutch and try again it seems to work fine.

Is something about to break?

Cheers


Biggriff

2,312 posts

313 months

Saturday 11th August 2007
quotequote all
sounds like slave cylinder. Check clutch fluid level

Richard

davido140

Original Poster:

9,614 posts

255 months

Monday 13th August 2007
quotequote all
cheers thanks,

got the car booked in at racing green for some other stuff early next month, will have them look at that too!

Oilyboy

21 posts

231 months

Friday 17th August 2007
quotequote all
I have a similar problem driving home tonight the handbrake light came on and buzzer sounded then clutch pedal went to floor (no resistance at all) The fluid is low so filled up but the worry is where is it going as usually they dont need topping up. Anyone had this happen and did it need a new slave cylinder

Biggriff

2,312 posts

313 months

Saturday 18th August 2007
quotequote all
"yes" had it happen to me. The dealer rebuilt the slave cylinder. all ok after that.

Richard

dvs_dave

9,040 posts

254 months

Saturday 18th August 2007
quotequote all
Biggriff said:
"yes" had it happen to me. The dealer rebuilt the slave cylinder. all ok after that.

Richard
Rebuilt slave cylinder.....why not replace it with a new one? In my experience rebuilt ones never last.

Biggriff

2,312 posts

313 months

Saturday 18th August 2007
quotequote all
Warranty job i'm afraid. I had no choice.

Seems fine after a few thousand miles though.

Richard

Whitey

2,508 posts

313 months

Sunday 19th August 2007
quotequote all
davido140 said:
cheers thanks,

got the car booked in at racing green for some other stuff early next month, will have them look at that too!
I personally would not risk driving it until fixed, unless you fancy being stranded.

Oilyboy

21 posts

231 months

Sunday 19th August 2007
quotequote all
Is it worth changing the clutch while the gearbox is out the mileage is very close to 30K.
Also has anyone had experience of the Raceproved clutch and alloy slave cylinder. Does it perform better than the usual fitment. I only ask as the blurb says its "re-engineered " to remove some of the failings of the TVR original fitment

Whitey

2,508 posts

313 months

Sunday 19th August 2007
quotequote all
30K on the original clutch then yes, time to change. Also change the slave. Consensus is TVR clutches can go anytime after 20K, alhough it depends on how the car has been driven and if the clutch has been set up correctly during that time. I know of a few lasting well past 35K.

Raceproved clutches and slaves are supposed to be much better, but apparently in short supply, more discussion on this in the Cerbera forums.

Oilyboy

21 posts

231 months

Sunday 19th August 2007
quotequote all
Cheers Thanks . I will now visit the "Dark side " and check the Cerbera forum

davido140

Original Poster:

9,614 posts

255 months

Sunday 19th August 2007
quotequote all
Whitey said:
davido140 said:
cheers thanks,

got the car booked in at racing green for some other stuff early next month, will have them look at that too!
I personally would not risk driving it until fixed, unless you fancy being stranded.
Ive done about 600 miles since I noticed the problem and oddly it hasnt done it again since. I'll have it looked at when the car is in the garage for other stuff next month, to be honest if it does break and Im stranded I dont mind as I have the AA breakdown insurance cover so they pay the first £500 of repairing it! smile