Freeview Reception
Author
Discussion

neilesh86

Original Poster:

121 posts

248 months

Saturday 11th August 2007
quotequote all
According to the website I should be able to get Freeview channels

I've also checked my aerial box and it's got Freeview reception stated on it and I checked the make and model on a Freeview website for recommended aerials and it was on the list

Finally, my aerial seems to point in the same direction as the others on my road, yet I can't get freeview - only channels I can get are the Beeb ones and even they keep breaking up

Any ideas?

The box doesn't even pick up any of the other channels never mind have a poor reception

And I've checked with a friend's Freeview box to make sure I'm not simply using a duff box!

Scraggles

7,619 posts

255 months

Saturday 11th August 2007
quotequote all
presume u tried tuning it in, all the connectors in the right hole ?
using main aerial and not set to box...

neilesh86

Original Poster:

121 posts

248 months

Sunday 12th August 2007
quotequote all
yeah tried that with no luck!

jmorgan

36,010 posts

315 months

Sunday 12th August 2007
quotequote all
Cabling up to scratch? Try the cable direct to the telly. That is through nothing else. Any reception then?

Hut49

3,544 posts

293 months

Sunday 12th August 2007
quotequote all
presuming everything is connected up ok the signal may be just below the threshold and you may need to visit Maplins for signal booster - could be that your neighbours' have one of these fitted hence why they can get channels you can't. I tried one for my Mum's house and it produced a load of channels that the Freeview box previously didn't see or couldn't convert.

trackcar

6,453 posts

257 months

Sunday 12th August 2007
quotequote all
I have to run my aerial through a signal booster and through the in-built booster i my video before the freeview box will work .. and even then it's sometimes a bit hit and miss. technology hey? pah!

jmorgan

36,010 posts

315 months

Sunday 12th August 2007
quotequote all
Personally, if I needed to boost then I would ask is the aerial correct, cabling in good order and correct type and if at all possible, boost up the top not down below. Then try a booster from somewhere you can return it if it does not work. Even if it does work, can you get a better one?

I also solder the center pins (unless its the screw type), found a difference on my telly a few years ago.

cjs

11,723 posts

282 months

Sunday 12th August 2007
quotequote all
Can you see an good analogue picture? Can you get all 5 analogue channels? If you can then you should also get the digital signal, if not you have a crap signal and need to sort it.

trackcar

6,453 posts

257 months

Sunday 12th August 2007
quotequote all
I'm at the bottom of a big hill and can't even get CH5 through my normal tv, i can only watch it through freeview. I think I just have a very weak signal area and need my aerial on a 100ft pole hehe the boosted signal works jus fine though, but needs lots of boosting.

VEX

5,259 posts

277 months

Sunday 12th August 2007
quotequote all
Boosting is not the correct answer though, technically.

An amplifier (booster) is just that, a small device that amplifies all the signals it receives, that includes all the noise and crap arround it.

If the ratio between the desired signal and the noise is ok, and it is only the level that is low then a amp may just do the job. However if the signal to noise ratio is low then no matter how much amplification you give it the picture will always be bad.

Freeview receivers are improving all the time and are able to cope with lower Signal to Noise ratios, but watch out for the cheaper ones as they may be less tollerant

HTH.

Vex