Mill light

[betty_swallocks]

Hi all

I have just refitted my clutch and now find that the mill light is staying on

Any guesses what I've done wrong or what I have missed

TIA

betty

[JensenA]

Havent reconnected the Lambda sesnors ?

[betty_swallocks]

Does it matter if Ive got left snd right mixed up

[marcus1970]

betty_swallocks said:

Does it matter if Ive got left snd right mixed up

Yes it does...

MB

[betty_swallocks]

would that make the mil light stay on

[Extra 300 Driver]

betty_swallocks said:

would that make the mil light stay on

Yes!

The ECU would be all over the place adjusting the fueling on the RH bank to try and reduce the valves but it will actually reduce on the LH side!

[betty_swallocks]

I'l have a crack at it when I get home from work (if it aint to late) and will let you know how i get on

Thanks for the help guys

Betty

[betty_swallocks]

Ive tried the connections to the Lambda sensors and tried swopping sides and still the mil light stays on

Any ideas what else it could be

Many thanks

Betty

[marcus1970]

betty_swallocks said:

Ive tried the connections to the Lambda sensors and tried swopping sides and still the mil light stays on

Any ideas what else it could be

Many thanks

Betty

Water in the wiring most probably - get the hairdryer out and make 'em bone dry and see if it turns off.

Or...one of your sensors not reconnected properly - tps, air etc?

MB

[betty_swallocks]

Found the problem

I had knocked the Air temp sender connector off DOH

Now I am a bit bothered that I have the lambda sensors mixed up

Can anyone tell me the colours of the wires going to the right hand side as I have had the sensors connected and then swapped over etc and now i cant remember which was which

[marcus1970]

betty_swallocks said:

Found the problem

I had knocked the Air temp sender connector off DOH

Now I am a bit bothered that I have the lambda sensors mixed up

Can anyone tell me the colours of the wires going to the right hand side as I have had the sensors connected and then swapped over etc and now i cant remember which was which

Should have a yellow label with odd and even on the wires to the loom.

...or else can connect to one sensor and look at the lap top and it will tell you which lambda is connected.

MB