Upper wishbone refit

[Billy_rfc]

Hey guys need some advice. After stripping my front suspension down to get it sand blasted and painted I've finally got round to rebuilding it all. Every things went fine until I tried fitting the upper wishbone. I connected up the front half with the two spacers but cant remember a spacer coming off the rear bush but it needs one so now need to know, is there a single spacer that fits between the bush and the chassis or are washers used to fill in the gap?

Cheers Billy.

Edited by Billy_rfc on Sunday 9th September 12:05

[plasticman]

There are two top hat spacers that locate the bush on the bolt . The larger one goes up against the mounting so the wishbone clears the lip.

[Billy_rfc]

plasticman said:

There are two top hat spacers that locate the bush on the bolt . The larger one goes up against the mounting so the wishbone clears the lip.

Cheers, cant find them anywhere! Doh.

Billy.