Tail Tidy CBR600rr

[Steve11]

Would like to replace the monstrosity that is on my CBR, any advise on where to get one?

[M5Player]

Have a look on 600rr.net - its been done to death on there!

[shot2bits]

Just fitted an evotech tail tiday on my R1, they also do the CBR600RR I believe...

Link below...

evotech

Let me know if you buy one...

Rob.

Edited by shot2bits on Tuesday 11th September 09:06

[Steve11]

shot2bits said:

Just fitted an evotech tail tiday on my R1, they also do the CBR600RR I believe...

Link below...

evotech

Let me know if you buy one...

Rob.

Edited by shot2bits on Tuesday 11th September 09:06

Looks Good, I'll order one today... any tips on fitting or is it pretty straight forward.... did you get a smaller plate, I was thinking of a 7x5.

[castrolcraig]

the best ones seem to be from ermaxuk.co.uk

several of my freinds fitted them and say easy to fit, looks good and very light!!

[308mate]

Try here

http://www.fabproducts.co.uk 

He makes good stuff and he's a nice bloke(and possibly someone I know).

PB

Edited by 308mate on Thursday 13th September 15:26

[shot2bits]

Fairly easy to fit - got to obviously remove the old one and disconnect electrics. Need to make sure you thread the wires through the new tidy as it'll be difficult to do once connected.

[Steve11]

Spent a couple of hours fitting the tail tidy today (if I had to do it again it would take 30 mins - if you know what I mean)

Now should I have bought the micro indicators as well

[shot2bits]

Steve11 said:

Spent a couple of hours fitting the tail tidy today (if I had to do it again it would take 30 mins - if you know what I mean)

Now should I have bought the micro indicators as well

Looks good, I thought the same thing about the micro indicators.

[ricky_3dr]

I would highly recommended evotech, recently fitted one to my R6, the fit is spot on