Airflow meter to Plenum (+other) hoses

[seb400]

I'm close to getting the car back together after some major chassis renovation. I really need to replace the airflow meter to plenum hose - would anyone have a suggestion for a replacement?
I also need to replace the air vent hoses, lower bonnet to bulkhead hoses. Again does anyone have suggestions for replacements for these?

MTIA Steve

[tubbystu]

http://cgi.ebay.co.uk/Range-Rover-TVR-SD1-Vitesse-...

may also still be stocked by Range Rover as spare part ?

[GreenV8S]

I used some concertina rubber induction pipe that original came from a Jag, but I don't know which one. Is the meter lined up with the throttle well enough to get away with silicon hose? You could be in trouble with that if your engine mounts are knackered though.

[HarryW]

I used silicon if you have it short enough it is strong enough to support the weight of the AFM without having to attach the AFM to the body, so it is always aligned with the throttle. I also put a bit of fire blanket under it to keep the heat of the manifolds off it too :thumbsup: worked for me very well.

[ketvrin]

I was intending to buy some air ducting from these guys for the ventilation hoses...

https://secure.visav.co.uk/avshop/products.asp?get...

K