Torque Settings?

[WIL35]

Just been fixing a few water leaks and other jobs that usually mean draining the system a bit, while my radiator is out being reconditioned.
Replaced the wiper park switch (very pleased about that) and replaced the 'O' rings on the nearside water rail. While doing this I was wondering if there is a list of torque settings, like you get at the beginning of each chapter in a Haynes manual?

[Dev255]

I would't go over 15 lb with radiator o-rings, about finger tight plus 180 degree turn without torque wrench. Best to do it loose, then run the engine to top temp and see if there are any leaks. tighten up as necessary, Making sure radiator has cooled first though!!!!

Happy Burbling!!

Edited by Dev255 on Thursday 27th September 09:24