Rear Bumper Removal
Rear Bumper Removal
Author
Discussion

toby tucker

Original Poster:

648 posts

295 months

Saturday 6th October 2007
quotequote all
how easy is to remove the rear bumper as a DIY proposition?

I'm going try and replace the exhaust/turbo heat shields myself - OPC quote of £700+ is taking the pi$$.

996TT_STEVO

4,078 posts

259 months

Sunday 7th October 2007
quotequote all
toby tucker said:
how easy is to remove the rear bumper as a DIY proposition?

I'm going try and replace the exhaust/turbo heat shields myself - OPC quote of £700+ is taking the pi$$.
Toby, r u sure this shield needs replaced, they never really rust as I mentioned before.

You best leave it and wait till you get a plug service, honestly!

I have just done mine, as I was doing plug change, but if you were to do it I would recommend you change plugs also at sametime, It does no harm! Would take you 4-5hrs tops (for a DIY Newbie)

I would wait but if your thinking of doing it send me a pm.

SkinnyBoy

4,635 posts

289 months

Sunday 7th October 2007
quotequote all
its easy, i recently repainted a 996 rear bar, remove the taillights first then the bumper is a cinch to get off. Get someone to help remove it, one on each side, you don;t want the ends to flick up and scratch your rear quarters.

toby tucker

Original Poster:

648 posts

295 months

Monday 8th October 2007
quotequote all
Thx for the feedback guys.

I had my local garage put it up on their ramps today to take a look for myself.

The turbo heat shields are definately past their best & could do with replacement now - however the exhaust heat shields are fine & should last for a while.

The job itself doesn't look as if it needs any specialist skills - easiest route looks to be disconnecting the whole exhaust/manifold assembly from the engine which looks straightforward - except that there's some additional plumbing work that would need to be disconnected before the assembly can be extracted from the rear of the car. Also there's 8 bolts attaching the rear exhaust box to the turbo manifolds that are past their best and will need to burned off with an oxy-act torch which is beyond my skill set - now where's my nearest kwik fit dealer ?!! hehe





Edited by toby tucker on Monday 8th October 20:00