964 Cup alloys
Discussion
Help, I have a set of 965 turbo cups with 7 55 on fronts and 9 55 on backs cast in the alloy, are they to big to fit a standard 964 body car to be lowered to RS level ,bearing in mind the RS had modded wheel arch edges. If so what size tyres. Also where locally to Reading can I get them sprayed a different colour?
Ian
Could I ask if the 225/45s need the 5mm spacers to fit (mines a 91 C2 on a 92 plate with 17" cup2s) and if so do the rears (255/40s)also need spacers
I went 215/45 fulda fronts to conti SC2 205/50 N2s and the front runs wide a bit now so am considering fitting 225/45s conti sc2s
Also, what is the difference between the 91 and 94 load tyres in terms of performance
Thanks, B
Could I ask if the 225/45s need the 5mm spacers to fit (mines a 91 C2 on a 92 plate with 17" cup2s) and if so do the rears (255/40s)also need spacers
I went 215/45 fulda fronts to conti SC2 205/50 N2s and the front runs wide a bit now so am considering fitting 225/45s conti sc2s
Also, what is the difference between the 91 and 94 load tyres in terms of performance
Thanks, B
The backs will fit, depending on the brand of tyre you might get slight rubbing on the oil line in the RH wheel arch, however the line can be flattened a bit if this does happen.
Spacers up to about 5mm are OK with standard studs - this is what I was using on my C2 which was quite heavily tracked with no problems. Any thicker and you need to think about longer studs, or the spacers that bolt onto the existing studs and have their own studs for the wheels.
I never tried the 225/45 fronts without spacers, as I had a '90 C2 and used the spacers to stop the inner wheel arch rubbing (even with 205/50 tyres). Rears shouldn't need spacers at all, though you could use 3-5mm for a little extra clearance if you like.
I'll be there on Sunday (assuming I get my car back from GT1 before then) - maritime blue RS cup car. Sold my C2 a few weeks ago, but went through all the wheel/tyre spacer issues whilst I had it. Finally ended up with 225/45 R888s on 7x17ET55 Cup1s on the front with 5mm spacers, and 255/50 R888s on 9x17ET55 at the back.
Spacers up to about 5mm are OK with standard studs - this is what I was using on my C2 which was quite heavily tracked with no problems. Any thicker and you need to think about longer studs, or the spacers that bolt onto the existing studs and have their own studs for the wheels.
I never tried the 225/45 fronts without spacers, as I had a '90 C2 and used the spacers to stop the inner wheel arch rubbing (even with 205/50 tyres). Rears shouldn't need spacers at all, though you could use 3-5mm for a little extra clearance if you like.
I'll be there on Sunday (assuming I get my car back from GT1 before then) - maritime blue RS cup car. Sold my C2 a few weeks ago, but went through all the wheel/tyre spacer issues whilst I had it. Finally ended up with 225/45 R888s on 7x17ET55 Cup1s on the front with 5mm spacers, and 255/50 R888s on 9x17ET55 at the back.
Gassing Station | Porsche General | Top of Page | What's New | My Stuff



