924 fouling plug and burning oil, advice?
Discussion
Hi all,
A teccy one.
My old 924 has been burning a lot of oil as late, maybe a litre every 3-400 miles which is excessive. The car smells of burnt oil although there isn't any obvious smoke. The plugs are all slightly black and sooty but one in particular is fouling with oily deposits. I've had to change it once and I cleaned it out again over the weekend.
I've done a compression test and three cylinders were at 170 psi with one, cylinder no. 4 (the one that is fouling plugs) lower at 140 psi. I squirted WD40 (is this thick enough?) into the bore and repeated with no change in the reading which may suggest valve leakage rather than rings?
It's an '82 2.0 Lux with 105K on the clock.
1) Is this a common problem for the 924 engine, if so what is normally the cause?
2) Does this sound like a worn ring or valve seal/guide?
3) Finally, is it possible to change a valve seal on this engine without removing the head?
Sorry for all the questions but any help would be very appreciated.
A teccy one.
My old 924 has been burning a lot of oil as late, maybe a litre every 3-400 miles which is excessive. The car smells of burnt oil although there isn't any obvious smoke. The plugs are all slightly black and sooty but one in particular is fouling with oily deposits. I've had to change it once and I cleaned it out again over the weekend.
I've done a compression test and three cylinders were at 170 psi with one, cylinder no. 4 (the one that is fouling plugs) lower at 140 psi. I squirted WD40 (is this thick enough?) into the bore and repeated with no change in the reading which may suggest valve leakage rather than rings?
It's an '82 2.0 Lux with 105K on the clock.
1) Is this a common problem for the 924 engine, if so what is normally the cause?
2) Does this sound like a worn ring or valve seal/guide?
3) Finally, is it possible to change a valve seal on this engine without removing the head?
Sorry for all the questions but any help would be very appreciated.

You'd need something a bit thicker than wd40 to do seal up the cylinder for testing.
I have one too which is a bit smokey like this and similar mileage. Mine however has only ever been stopped and started to
move it around a drive a few times in the past 3 years so I'm putting it down to needing a good thrap!
I have one too which is a bit smokey like this and similar mileage. Mine however has only ever been stopped and started to
move it around a drive a few times in the past 3 years so I'm putting it down to needing a good thrap!
Gassing Station | Porsche General | Top of Page | What's New | My Stuff


