What to look for on a 996 Turbo
What to look for on a 996 Turbo
Author
Discussion

jamiep

Original Poster:

1,791 posts

250 months

Sunday 14th October 2007
quotequote all
Hi guys,

Im looking to get a 996 manual turbo in the next couple of weeks, my budget is 45k tops so will be looking at early ones and i was after some advice on what to look for when looking? what goes wrong with them if anything?

Regards Jamie

USS Bozeman

1,084 posts

253 months

Sunday 14th October 2007
quotequote all
I would get it inspected by an OPC or good specialist before buying for sure.

The good news is that the major (expensive) bits (engine / gearbox) seems very very strong and failures on those are uncommon.

I am assuming you are looking at 2001/2 cars with 35k+ miles on it ? At that mileage there are certain common things that fail on turbo's (heat shields, suspension arms/ front rads etc) and I would get the clutch checked for wear unless its been recently changed.


Porsche Tech

102 posts

232 months

Sunday 14th October 2007
quotequote all
All the above for sure, all 3 rads will need replacing soon and air con condensers
engine and box is strong, occasional rear main oil leak, discs and pads all round ill be corroded on the inside too, if the clutch feels heavy or clicky its wrong, should be very light, its a PAS pump assisted clutch

pennpromo

121 posts

287 months

Monday 15th October 2007
quotequote all
Hi, I brought my "X" reg car about four months ago now, was showing 39,000, now just over 45,000. Uses a fair amount of Mobil 1, I guess I have added about three litres, habitualy check now as I fill up, its so easy with the electronic gauge. Had a new air con condenser as part of the purchase as it was in-effective. Done a few trackdays and still got some rear tyres left. Always clear leaves and muck out from font of rads. Absolutely awesome car but as above do buy from a respected dealer or get an OPC inspection. I went for the former, Westover Sportscars in Poole, came with a warranty, more or less worthless, but they have proved to me in the past that they do look after their customers with any post sale problems. So far so good, and so quick ! REally can't think of anything else that I would change for.

Little Dave

882 posts

240 months

Monday 15th October 2007
quotequote all
Have had mine for a year now and have done 15k in it (34k in total). The only real problem I have had with it is the second gear synchro failing. Apparently this is not uncommon with the 996tt with my local OPC doing one every month or so.

DirkDiggler

253 posts

262 months

Monday 15th October 2007
quotequote all
Little Dave said:
Have had mine for a year now and have done 15k in it (34k in total). The only real problem I have had with it is the second gear synchro failing. Apparently this is not uncommon with the 996tt with my local OPC doing one every month or so.
what are the symptoms of the second gear synchro failing? mine is, well, notchy i guess. Bit of a struggle to get it into 2nd, especially compared to the others which are smooth as silk.

MICHAEL D

54 posts

254 months

Monday 15th October 2007
quotequote all
DirkDiggler said:
Little Dave said:
Have had mine for a year now and have done 15k in it (34k in total). The only real problem I have had with it is the second gear synchro failing. Apparently this is not uncommon with the 996tt with my local OPC doing one every month or so.
what are the symptoms of the second gear synchro failing? mine is, well, notchy i guess. Bit of a struggle to get it into 2nd, especially compared to the others which are smooth as silk.
My '03 turbo occasionally jumps out of second gear, is this a synchro problem, or gearbox?

Cheers
Mike

Little Dave

882 posts

240 months

Monday 15th October 2007
quotequote all
If you drive along with your hand resting on your gearknob and come off the power you shouldn't really feel anything move. When the second gear synchro is beginning to wear you can feel the stick jump but not disengage.When it is really worn it will jump out of gear when you come off the power.

Mine was doing it maybe 1 in 10 trips to start but within a couple of months it was happening almost every journey. It was a no quibble warranty fix with the OPC that would have had me £4.5k out of pocket otherwise.

USS Bozeman

1,084 posts

253 months

Monday 15th October 2007
quotequote all
I think there are 2 different problems here. Second gear synchro failing is a bad problem, requiring a gearbox re-build (v expensive) Symptoms usually is that the car jumps out of second gear at low speeds.

There is also another minor issue with gearbox's in that Porsche use a plastic retaining clip (or something like that - sure someone else will correct me) that can fail pretty easily. Some replace it with a metal one but this is a common problem (the one probably that Porsche are sorting every month or so. It doesn't damage the gearbox and when replaced all is fine. When it happens though you lose the ability to change gear, so can appear like a major problem when / if it happens, but it isn't.

Generally, 996TT's are a little notchy going into 2nd gear, often it gets better when warmed up but never completely goes away. Mine is notchy going into second and I had a specialist look at it and they said all was well.

Little Dave

882 posts

240 months

Monday 15th October 2007
quotequote all
MICHAEL D said:
DirkDiggler said:
[quote=Little Dave]Have had mine for a year now and have done 15k in it (34k in total). The only real problem I have had with it is the second gear synchro failing. Apparently this is not uncommon with the 996tt with my local OPC doing one every month or so.


what are the symptoms of the second gear synchro failing? mine is, well, notchy i guess. Bit of a struggle to get it into 2nd, especially compared to the others which are smooth as silk.


My '03 turbo occasionally jumps out of second gear, is this a synchro problem, or gearbox?

If it is jumping out when you have come off the power then it sounds like the 2nd gear synchro is beginning to go. This will eventually require a new input shaft,(this includes first and second gear) and a gearbox rebuild. As I mentioned earlier OPC treat this as a warranty issue and it is a great time to have a clutch replaced if needed as you will only have to pay for the parts saving £1600 on OPC prices.




Edited by Little Dave on Monday 15th October 16:07

MICHAEL D

54 posts

254 months

Monday 15th October 2007
quotequote all
Little Dave said:
MICHAEL D said:
DirkDiggler said:
Little Dave said:
Have had mine for a year now and have done 15k in it (34k in total). The only real problem I have had with it is the second gear synchro failing. Apparently this is not uncommon with the 996tt with my local OPC doing one every month or so.
what are the symptoms of the second gear synchro failing? mine is, well, notchy i guess. Bit of a struggle to get it into 2nd, especially compared to the others which are smooth as silk.
My '03 turbo occasionally jumps out of second gear, is this a synchro problem, or gearbox?

If it is jumping out when you have come off the power then it sounds like the 2nd gear synchro is beginning to go. This will eventually require a new input shaft,(this includes first and second gear) and a gearbox rebuild. As I mentioned earlier OPC treat this as a warranty issue and it is a great time to have a clutch replaced if needed as you will only have to pay for the parts saving £1600 on OPC prices.

Thanks Dave,
Thankfully have recently renewed my warranty, so should not be a problem. Mine is similar in that it only happens now and again, so could not take it to OPC and show them the fault. Will they do this work on my request (new input shaft) or would it need to be happening every journey before they look at it?
Cheers
MIKE



Little Dave

882 posts

240 months

Monday 15th October 2007
quotequote all
Depends on which OPC you go to. Mine went to Mid Sussex and it would not replicate the fault the first time I took it there. They did not want to strip it all down until they had actually seen it jump. I left it a month and it got gradually worse. The next time I took it to Burgess Hill it jumped out before the mechanic got it off the forecourt. 3 days later and with a new clutch, the car was back

Just as an aside OPC do get a kicking on here every now and again. Personally the service I got from OPC Mid Sussex and in particular Gron (Head Mechanic) over this matter was superb.

Apologies for to the OP for going slightly off topic

MICHAEL D

54 posts

254 months

Tuesday 16th October 2007
quotequote all
Little Dave said:
Depends on which OPC you go to. Mine went to Mid Sussex and it would not replicate the fault the first time I took it there. They did not want to strip it all down until they had actually seen it jump. I left it a month and it got gradually worse. The next time I took it to Burgess Hill it jumped out before the mechanic got it off the forecourt. 3 days later and with a new clutch, the car was back

Just as an aside OPC do get a kicking on here every now and again. Personally the service I got from OPC Mid Sussex and in particular Gron (Head Mechanic) over this matter was superb.

Apologies for to the OP for going slightly off topic
Thanks for the advice Dave,
I will wait till it gets progressively worse and then take it to my OPC (Tonbridge)

Mike