Electrics connection
Electrics connection
Author
Discussion

paultither

Original Poster:

1,320 posts

231 months

Saturday 20th October 2007
quotequote all
Simple question folks, I'm changing the lights on my boxster and need to locate the main electrical connector and disconnect it whilst I'm changing them, where abouts is this located?

Testarossa

1,050 posts

252 months

Saturday 20th October 2007
quotequote all
Maybe I've not understood the question, but why do you need to do this?

To change the lenses, take away the carpet, unclip or unscrew (can't remember) the bulbholder, unscrew the lens and push out.

AsifG

472 posts

247 months

Saturday 20th October 2007
quotequote all
and what if he wants to change the bulbs smartass?

Edited by AsifG on Saturday 20th October 18:56

GreenV8S

31,027 posts

315 months

Saturday 20th October 2007
quotequote all
AsifG said:
and what if he wants to change the bulbs smartass?
Are you suggesting that the OP would need to disconnect the electrics to change a bulb? confused

wildoliver

9,325 posts

247 months

Saturday 20th October 2007
quotequote all
AsifG said:
and what if he wants to change the bulbs smartass?

Edited by AsifG on Saturday 20th October 18:56
It's you who's the smartass, and been left looking a prat.

To change the bulbs unplug bulb, remove bulb, replace bulb, plug back in???

With regard to main electrical connector, I can only assume you mean battery earth lead, always advisable to disconnect on certain jobs, eg starter motor removal, however not necessary on anything to do with headlights.

Porsche Tech

102 posts

232 months

Saturday 20th October 2007
quotequote all
SAD

Testarossa

1,050 posts

252 months

Sunday 21st October 2007
quotequote all
AsifG said:
and what if he wants to change the bulbs smartass?

Edited by AsifG on Saturday 20th October 18:56
Well, in that case, just remove the bulb holder and gently push out the bulbs.

My porsche clinic is always open!

thegoose

8,077 posts

241 months

Sunday 21st October 2007
quotequote all
If it's one of the front lights you're changing then simply RTFM!

This basically means pulling back the (front) boot carpet, removing a big rubber grommet, then insert the light unit removal tool (which comes in the car's toolkit), turn it a quarter turn to release the light unit. Then simply carefully pull the whole light unit out from the front. The electrical connector is at the rear and disconnects automatically when you remove the light unit.

Whole process takes about 30 seconds - much quicker than watching others' antagonistic replies about who knows best rolleyes

wildoliver

9,325 posts

247 months

Sunday 21st October 2007
quotequote all
I've just had a quick look at the chaps profile, your not far from me paul, if you fancy a trip over the humber bridge (I live about 30 mins the other side) then I'll happily give you a hand to do them. (no charge it's only a 5 min job.)

AsifG

472 posts

247 months

Sunday 21st October 2007
quotequote all
Testarossa - Told you before, and I'll say it again. They dont understand.....

paultither

Original Poster:

1,320 posts

231 months

Tuesday 23rd October 2007
quotequote all
All sorted, it was a five minute job. The reason I asked is because when I removed the frist indicator the alarm went off. I was scared I had f.. messed something up but everything is fine and in fully working order. Thanks for the help (and arguments)