944 Lux vs 944 S2 et al track & geometry
944 Lux vs 944 S2 et al track & geometry
Author
Discussion

alanruss

Original Poster:

1,138 posts

257 months

Monday 29th October 2007
quotequote all
Hi All,

I hope someone can help but I own a 1983 2.5 Lux and I have worn a rear tyre and as a result I swapped from the special Club Sport Alloys (like Design 90's but without the lip) and the car is running on some whopping spacers on the front and rear (prev owner additions) prob about 27 - 30 mm????! . So what I wanted to know as seeing as these are from a turbo / silver rose / 944 s2 I assume rather than a 928 which I know also used them, do the later 944 models come with a wider track than the early models. I am going to sell mine and will keep these wheels and use the standard cookie cutters until then I think.

Thanks in advance!

PS I think the low profile and spacers is what is giving me a hard time on my Lux steering probs like tramlining etc etc

HAB

3,632 posts

258 months

Monday 29th October 2007
quotequote all
Later 944's wheels (post '85) have a different offset to the early cars. I'd put the cookie cutters back on if i were you, or ideally a set of Fuch from the same era (they were an expensive option on the early cars.)

HTH

Riverside

319 posts

249 months

Monday 29th October 2007
quotequote all
If you fit late offset wheels to an early offset car you need spacers of about 30mm to get the offset right. It would appear yours has these so you're sorted biggrin

If the wheels fill out the arches reasonably well then they're in the right place. Without the spacers they'd be buried under the arches & possibly rub on the inside.

Get the tracking checked, your car & wheel combination shouldn't have any particularly odd wear if the tracking's right.

If you like the looks (I do) stick with the clubsports, they're just about the lightest 16" wheel Porsche made & certainly much, much cheaper than equivalent sized fuchs.

Nurburglover

76 posts

243 months

Tuesday 30th October 2007
quotequote all
Bad wheel alignment is the reason for the tramlining. You need the 4 wheel laser job to sort it. Oversize wheels make them very sensative. Did this to mine & it's spot on now.

NJH

3,021 posts

240 months

Tuesday 30th October 2007
quotequote all
Nurburglover said:
Bad wheel alignment is the reason for the tramlining. You need the 4 wheel laser job to sort it. Oversize wheels make them very sensative. Did this to mine & it's spot on now.
Can also be caused by worn shocks, worn top mounts and worn wishbone bushes or worst a combination of tiny amounts of movement in all of them adding up to a car that tramlines all over the place.