944 S2 Cab Gear lever stiff !
Discussion
Just bought a 944S2 cab and have found the gear lever action in the side to side plane stiff,does anyone know how to remedy this ?
Also the rear plastic window is opaque and needs replacing,anybody know the cheapest/best route to make the hood look good.
Another problem I have is the speedo needle is erratic,the speedo clocks up miles but the needle does its own thing !!
Apart from all that the car is great to drive and I should have bought one sooner !!
Also the rear plastic window is opaque and needs replacing,anybody know the cheapest/best route to make the hood look good.
Another problem I have is the speedo needle is erratic,the speedo clocks up miles but the needle does its own thing !!
Apart from all that the car is great to drive and I should have bought one sooner !!

The stiff gear change will be the shift knuckle on the gearbox - budget a couple of hundred pounds to replace - transforms the shift once sorted.
Speedo pickup is on the 'box also, electronic sender - about fifty quid.
Try Boxster rear window polish before replacing the window, its a special cutting cleaner that brings most things back to see-through
Speedo pickup is on the 'box also, electronic sender - about fifty quid.
Try Boxster rear window polish before replacing the window, its a special cutting cleaner that brings most things back to see-through
Edited by Pope on Wednesday 31st October 14:13
v8yea said:
Does the gearbox have to come out or can you do these jobs with it in situ ?
You might get away with just removing the exhaust back box for access, if the mechanism needs to be replaced I'm not sure it can be done without dropping the torque tube. It's one of those jobs to do 'while you're there' when replacing the clutch.You can remove the plastic knuckle joint without removing the gearbox. We re-bush the plastic but you can sometimes just remove the circlip, knock off the tight bush, clean up the shaft and re-grease.
Beware the large bolt head on the RHS of the gearbox that is a 17mm spanner size - it is only an 8mm thread - don't overtighten it.
The hexagon bolt with the locking wire is also often stuck or seized and needs drilling out - requiring a special drill to reach it.
Baz
Beware the large bolt head on the RHS of the gearbox that is a 17mm spanner size - it is only an 8mm thread - don't overtighten it.
The hexagon bolt with the locking wire is also often stuck or seized and needs drilling out - requiring a special drill to reach it.
Baz
Gassing Station | Porsche General | Top of Page | What's New | My Stuff


