Bleeding 996 coolant!
Bleeding 996 coolant!
Author
Discussion

maxpaul

Original Poster:

451 posts

235 months

Thursday 1st November 2007
quotequote all
Fitting new Coolant Radiators today and would like advise on bleeding the air from the system
Is there a bleed valve in the system? Should the coolant be toped up anywhere else in the system other than the coolant tank?
Thanks

Paul 2002 C4S

richardb.jones

326 posts

256 months

Thursday 1st November 2007
quotequote all
It will take a number of runs to get all the air out system. Take some premixed coolant with you (2-3L) then I suggest getting the car to operating temp, then run it hard but not too far from a place where you can stop. The coolant light will no doubt flash at you after a minute or so of giving it full beans. So stop and slowly release the cap and top up to the max. When it's cold - check it again and it'll likely need another top up.

Mine needed 2 runs like this to get all the air out.

PS - There is a bleeder valve on top of the header tank (turn the metal bit upright and lock it in place) but your problem will be air in the system, not in the header tank.

I hope this helps ..

maxpaul

Original Poster:

451 posts

235 months

Friday 2nd November 2007
quotequote all
Thanks for the advice it is a bit scary running hot with the system requiring another 6 pints or so
In the end I disconnected the return pipes from the top the rads and got most of the air out that way Its nice to know the cooling system is nice and intact as I have a porsche track day at Goodwood next week and a steaming front end is not cool!

Paul C4S

Porsche Tech

102 posts

232 months

Friday 2nd November 2007
quotequote all
Drive it hard knowing you don't have enough coolant in??????? naah, use a vacuum bleeder and problem sorted.