tunning 993 TT
Author
Discussion

gary11

Original Poster:

4,163 posts

232 months

Friday 2nd November 2007
quotequote all
Hi all Iam thinking of a light tune and sports exhaust on my 993 TT I woulld like approx 500hp dont want to get to carried,I am led to belive my car has 430hp what would be the most reliable method do I need new turbos or can i remap ect
gary

935

250 posts

252 months

Friday 2nd November 2007
quotequote all
I believe a standard 993TT has 408 brake so 500 ish represents an additional 25%. This figure is relatively easy to achieve with more boost but it all depends what you want to do with the car. If you are going to track day it all day long you will need many, many modifications to keep the temperatures under control. These include, but are not limited to, oil coolers, intercoolers, internal engine mods, gearbox modifications etc etc. However, if all you want to do is a quick blast up the road then a good professional remap should get near the 500 mark. This will require more boost and will effect the reliability - believe me because I really do know!
Be careful, modifications like these are the begining of a long, slippery and hugely expensive slope!
Good luck,
Richard.

Marki

15,763 posts

301 months

Friday 2nd November 2007
quotequote all
Ask Deristrictor on here he had done some serious work on his

guyvert1

2,168 posts

273 months

Friday 2nd November 2007
quotequote all
I thought 500bhp was 'relatively' hard to acheive without alot of mods (k24's etc) on the 993TT ?

935

250 posts

252 months

Friday 2nd November 2007
quotequote all
It all depends on how hard you drive the engine. 500 brake can be achieved on the stock set up but it wont last long! Moreover, power will start to drop off almost immediately as the temperatures increase but for a short blast (30 seconds)it may suffice. A remap would not be my recomendation but it is possible. I suppose if all you want is a dyno sheet saying 500 brake it is fine but for real sustainable performance it wont do!
500 brake on a twin turbo race engine designed to run flat out for 2 hours will cost thousands and thousands of pounds and it still wont last all that long! The trouble with the air cooled engine is it runs close to its thermal limit and modifications to produce more power just make the situation worse!

As I said earlier, it is a long and expensive slope!

Richard.

gary11

Original Poster:

4,163 posts

232 months

Friday 2nd November 2007
quotequote all
I dont want to abuse my car as it is a nice one,I think I will just have a remap with no particular bhp in mind ,just optimise its settings so to speak,what do we reckon re exhuast,silencer and cat by pass,or branded sports exhaust?
gary

ACEparts_com

3,724 posts

272 months

Friday 2nd November 2007
quotequote all
I've got an ultimate motor works stage 2 kit coming from the states - the same as Phelix has fitted. APX 480 bhp for £4K

guyvert1

2,168 posts

273 months

Friday 2nd November 2007
quotequote all
They do top class turbos smile Good choice, who's doing the mapping?

ACEparts_com

3,724 posts

272 months

Friday 2nd November 2007
quotequote all
guyvert1 said:
They do top class turbos smile Good choice, who's doing the mapping?
It's a KIT - i.e. everything you need smile

lanesra10

314 posts

262 months

Monday 5th November 2007
quotequote all
ACEparts_com said:
I've got an ultimate motor works stage 2 kit coming from the states - the same as Phelix has fitted. APX 480 bhp for £4K
This basically the most coast effective solution, if you want to go higher you will be into the £10k + area. Check out Ultimate works site and Rennlist.com where all the experts hang out.

Agent Orange

2,078 posts

271 months

Monday 5th November 2007
quotequote all
Wayne Scholfield , Chips wizzard can safely remapp ur car and will remove a lot of the mid range boreing bits on ur ECU ..........he has done loads and knows exactly what to do ...........but do pay attention to what 935 says , have had a very sad converstaion with Richard of late concerning the demise of both my KK24 S on a 993 GT2 which spends most of its life on track days ..............u do nt need to get an awful lot wrong before the whols show goes bang , when u start hotting up , we re talking rods ,gaskets and materials like titanium ............i m sure Richard means once u change one internal its almost common sende economically to change another and so u go on , cracked ceramic ports flying off into all ur new bits , rods with extra heat and pressure popping out the side , u dont have to think SECAN cooler but a lot of the other things down to screws and bolts become fundamental as u approach 500 bhp

phelix

4,684 posts

280 months

Monday 5th November 2007
quotequote all
gary11 said:
Hi all Iam thinking of a light tune and sports exhaust on my 993 TT I woulld like approx 500hp dont want to get to carried,I am led to belive my car has 430hp what would be the most reliable method do I need new turbos or can i remap ect
gary
In my opinion... make sure your engine is strong and healthy before you start looking for more power. More power means more heat and more stress. Find out what the leakdown numbers are. What's the oil consumption?

gary11

Original Poster:

4,163 posts

232 months

Monday 5th November 2007
quotequote all
Hi felix am booked in for a check over for exactly that reason,seems all good burns hardly any oil,(up till my recent filter/oil problem anyway) now ok,may just have a remap and sports exhaust will wait and see,cheers gary

phelix

4,684 posts

280 months

Monday 5th November 2007
quotequote all
If you've got a 430 ECU then there isn't much more to be had from stock K16's. You might get to 440; try for anything more and you're overstressing the turbos and/or just overheating the charge air. Next step is perhaps £5K for a UMW stage 2 kit or a set of K24's with a better map than the Porsche 450 map.

gary11

Original Poster:

4,163 posts

232 months

Monday 5th November 2007
quotequote all
hi all thanks for the replyies,my boost has been playing up again,have got some traces of oil in pipework to intercooler ect,from my earlier filter problem,so octane is probably down,if the anti knock sensors pull timing for this reason does anyone know if it pulls the boost too?
nb I think I will get all hoses cleaned out,doesnt look to hard but dark at night now and am too busy!

gary11

Original Poster:

4,163 posts

232 months

Monday 5th November 2007
quotequote all
I dont suppose you have a number for the chip man agent orange?

cheers gary

turbo-ww

1,766 posts

247 months

Monday 5th November 2007
quotequote all
Am I the only one that thinks getting a dictionary to spell tuning would be beneficial prior to extracting 500 bhp from a standard 408???? getmecoatgetmecoat

Agent Orange

2,078 posts

271 months

Monday 5th November 2007
quotequote all
wayne@chipwizards.co.uk

07977 004476

As stated u wont get 500 on kk16 but u ll get the best going ...........

Ken993

412 posts

262 months

Monday 5th November 2007
quotequote all
Gary, I think you need to be so careful, if your tracking the car you will be putting alot of strain on the engine and if that's combined with a power upgrade on an engine with a few miles on it, you could end up with an engine rebuild that will cost you the other side of £10k.

I speak from experience after my engine went at Bedford.

If you do go for the upgrade you need to be sure that you have the additional oil cooler (standard on a 430 bhp car) and you may need to upgrae your dump valves and fuel regulator. Sports exhaust will not make much difference, you need to change the cats to 100 cell.

It's an expensive business fiddling with these cars, again I'm speaking from experience. I ended up retiring mine from track duty and buying a GT3.

935

250 posts

252 months

Tuesday 6th November 2007
quotequote all
Wow, time to chill!!! With a turbo it is fairly easy to get more power. You simply run more boost and remap the fuel and ignition. I know 500 brake can be achieved on K16s BUT the end result will be pretty useless. As said before by a number of people, the compressed air temperature will be too high, the turbos will be struggling as they will be close to overspeeding, the exhaust back pressure will be high thus massively increasing the EGT and the poor old internals will be hurting due to the combination of the boost and temperature. However, all this will only happen when you are flat out for a period of more than, say, 30 seconds. If you dont intend thrashing the car then it may be OK.
Now, if you want to build a sensible air cooled engine to produce a reliable 500 brake then we are taking about a completely different situation. I dont have any idea of your budget but I honestly expect you would die of fright - I know I did!

Obviously, I dont know what you want but it seems a good compromise would be around 450 brake with a strong torque curve running as low boost as possible. Your standard mechanical set up should do this but I would strongly recommend an addition oil cooler.

Good luck,

Richard.