DIY engine cross member replacement.
DIY engine cross member replacement.
Author
Discussion

LuckyP

Original Poster:

6,243 posts

256 months

Monday 5th November 2007
quotequote all
Anyone replaced the rear cross member on a 964?

I posted a couple of pics on another thread:



On closer inspection and removal of the back box, I reckon I can get at all the bolts/nuts, but still can't see if I can remove and replace the compoment with the engine in situ.

Any experience?

Pete

clubsport

7,420 posts

289 months

Monday 5th November 2007
quotequote all
Sorry, no experience,,,,but if you go to the 964 forum on www.rennlist.com and search under "crossmember" there seem to be a few people with more of a clue smile

LuckyP

Original Poster:

6,243 posts

256 months

Monday 5th November 2007
quotequote all
Ta CS I'll have a gander.

Lucky

wildoliver

9,325 posts

247 months

Tuesday 6th November 2007
quotequote all
The crossmember bolts to the car with the two big nuts at each end of the member, and to the engine in the centre with from memory 13mm nuts.

I think you will definitely have to remove the back box, and then if your really lucky you might be able to slide the old member out, if it's tight you may be forced to take the studs out too.

You shouldn't have to drop the lump.

Oliver

dilbert

7,741 posts

262 months

Tuesday 6th November 2007
quotequote all
This thread forced me to go and have a look. The 3.2 actually has a different arrangement from the 964, I'd forgotten that you have the M64 engine.



Irrespective I must have given you a bum steer in the other thread because, looking at it, I think I could replace mine without having to remove the engine.

Sorry, and good luck.

Edited to add;

Now I've looked at something similar, I think I'd be more worried about how to get the new one in, rather than how to get the old one out!!! Someone somewhere has documented a partial engine drop, where the majority of stuff remains connected, including the gearbox engine mounts. It has the potential to give enough room to disconnect the engine from the gearbox without removing the gearbox.

I've personally never been entirely comfortable with that approach, because it has the potential to get very awkward if things don't go according to plan, but it might be just the ticket.

I guess the deciding factor in all of this is how easy it is to work around the tinware.

Edited by dilbert on Tuesday 6th November 12:03