964 - Oil questions!!
964 - Oil questions!!
Author
Discussion

EDSEL1

Original Poster:

181 posts

229 months

Wednesday 7th November 2007
quotequote all
Hi all,

I recently bought a 964 --- the oil pressure now idles at 1 but goes up when I accelerate..is this normal.
The oil gauge remains on red - I put in 1 liter before a 800 km trip this weekend. the guage went up and down for a while, now remains on red. the dipstick indicates that all is well.
The engine does smoke a little after driving (white smoke, not blue) - any ideas?

Do I need to remortgage my house??

ian964

534 posts

283 months

Wednesday 7th November 2007
quotequote all
Ah, the black art of checking the oil level in a 964!

The oil level gauge will pretty much always show in the red unless the engine is idling, at full operating temperature with thermostat open, on level ground. This is because it's actually measuring the level in the oil tank.

At idle, the oil pressure gauge should show around 1-2 bar, going up to 5 when the engine is revved, so yours sounds normal in this respect.

mr pg

2,068 posts

236 months

Wednesday 7th November 2007
quotequote all
It normally idles around 2bar, and goes up to 5bar as you accelerate. Are you looking at the gauge when idling on level ground (which is when you should check this) or as you drive?
The dipstick should also be checked when idling on level ground, after engine is fully warmed up.

EDSEL1

Original Poster:

181 posts

229 months

Wednesday 7th November 2007
quotequote all
thanks for that. The dipstick level looks fine.

What about the smoke any ideas?
I drove it to France at the weekend without any probs, then took it for a quick burn last night and it did smoke some what - there is obviously a leak somewhere but I am getting worried......


ian964

534 posts

283 months

Wednesday 7th November 2007
quotequote all
Is it smoking when you first start it up, or all the time? Also, is it coming out of the exhaust or just around the rear wheels etc? They will often smoke on startup due to the horizontal cylinders - oil collects there and burns off when the engine is started. If the smoke is coming from the engine bay, could easily be a minor leak or overfill dripping onto the exhaust/heat exchangers. Check that the oil filler cap is tight, see if there are any signs of it leaking.

EDSEL1

Original Poster:

181 posts

229 months

Wednesday 7th November 2007
quotequote all
it smokes out the rear wheels - only after I have been for a drive, not on start up.

r5gttgaz

7,897 posts

251 months

Wednesday 7th November 2007
quotequote all
Have you overfilled it with oil?

EDSEL1

Original Poster:

181 posts

229 months

Wednesday 7th November 2007
quotequote all
Before driving to France I checked the dipstick and it seemed a little low. I put in 1 litre then drove about 800 kms. Thinking about it I may have overfilled it, the oil gauge was on red so I was getting worried. The guage does remain on red though.

boxsey

3,579 posts

241 months

Wednesday 7th November 2007
quotequote all
When you measure the oil using the gauge reading as pointed out above (fully warmed up on level ground at idle) the full deflection from red to top is only about half a litre. Hence you have to be careful when topping up. Personally I add 0.25 ml when the engine is running (as above) and wait 30 seconds and check the gauge before adding anymore. I try to not let the needle get much above half way.

You may be a bit overfilled at the moment hence it's sweating out a bit which is burning on the exhaust.

EDSEL1

Original Poster:

181 posts

229 months

Wednesday 7th November 2007
quotequote all
does it then stay on red when driving?

ian964

534 posts

283 months

Wednesday 7th November 2007
quotequote all
Yes, it will generally stay in the red unless the engine is idling (and has been for a few seconds)

HAB

3,632 posts

258 months

Wednesday 7th November 2007
quotequote all
Forget about the oil level gauge when your driving,it'll vary depending on the revs.

It only measures the level in the tank accuratley when idling and fully warmed up.i.e oil thermostat open and on level ground (the oil temp gauge should be at the 9 pm position or above when the thermostat is fully open)

ian964

534 posts

283 months

Wednesday 7th November 2007
quotequote all
Also bear in mind that the same applies to readings on the dipstick (i.e. engine idling etc.), as it's being dipped in the same tank as the gauge is measuring.

EDSEL1

Original Poster:

181 posts

229 months

Wednesday 7th November 2007
quotequote all
yep - the level temp stays nicely on 9 when fully warmed up.
Thanks for all your advice - I feel a lot better.

Apart from that I love it!! - only had it 2 weeks...

Bahnstormer

948 posts

277 months

Thursday 8th November 2007
quotequote all
My guage doesn't seem to read at all - do I need a new sender I have heard that a lot of guages don't read corrwectly on 964.

Is it a case of 'TADTS' or should I get a new sender ?

Cheers,

Rob

Pesty

42,655 posts

287 months

Thursday 8th November 2007
quotequote all
Bahnstormer said:
My guage doesn't seem to read at all - do I need a new sender I have heard that a lot of guages don't read corrwectly on 964.

Is it a case of 'TADTS' or should I get a new sender ?

Cheers,

Rob
Have you checked via dipp stick that you actualy have any oil in as well? If you do obviously at full temp on level ground then it could well be the sender.

Mine works fine and is pretty accurate gauge to what is shown on teh dip stick

HAB

3,632 posts

258 months

Thursday 8th November 2007
quotequote all
I actually prefer to use the gauge as the dipstick can be difficult to read accurately.

Edited by HAB on Thursday 8th November 17:55

911addict

394 posts

249 months

Thursday 8th November 2007
quotequote all
RTFM: Read the manual!
If you use the gauge, you must always check it when idle running, warm and on flat ground. The gauge is meaningless if the you are moving.
To get smoke through overfilling, you must be way over 1 litre too much. a litre is nothing compared to the total oil capacity.

rlw

3,590 posts

268 months

Thursday 8th November 2007
quotequote all
Its dead easy to slop a load of oil over a 964 motor as the filler is so crap and that is guaranteed to get you a bit of smoke. Mind you, 993s can be a pain too. I topped mine up in the garage at night in the shadow of the engine cover and didn't notice that I pushed the concertina pipe in before it was empty. (Oil on the floor next day). Nor did I notice that I forgot to put the filler cap back on. A few days later, about three miles from home, I floor it away from a set of lights (yes I know) only to see an F1 turbo engine blow up cloud of smoke in my mirror. Needless to say, I stop and switch off and stroll casually round the back, open the engine lid and am engulfed in white smoke. There is also a pool of hot smoking oil on the floor and I see ££££ signs like in a cartoon. Only when the smoke clears do I see the problem. Fcuk me, the smell of burnt oil took weeks to clear and driving back home to substitute the filler cap for the emergency old rag and bit of wire was a smke ridden nightmare. Oh well, you only do it once (or twice in my case....)