Paint Protection Experience
Paint Protection Experience
Author
Discussion

anglebox10

Original Poster:

2,733 posts

242 months

Friday 9th November 2007
quotequote all
Firstly this is not meant to be a Paintshield v Ventureshield thread, I think there's been much discussion on this already.

I chose the Paintshield route after a bit of research and initially had the whole front of my car covered from new.
I was a bit sceptical at first but figured with the car being black it should stop the front being peppered with white marks at least.
The finish of the initial installation which was NOT carried out at Paintshield HQ was not that impressive, but a re-installation was done and then looked very good.
After 4k miles I have been very impressed with the film protection, especially the ease of removing dead flies etc, it's good shine, no chip marks at all so far, and it's practically invisible.

Unfortunately after 4k miles I was also amazed at the numerous small chip marks appearing on the sills, doors, and rear wheel arches, all pretty visible in white of course, even a couple on the roof too.
I decided to bite the bullet before this got worse in the winter time, and had the sills partially repainted, and headed down to Paintshield HG in Grantham after speaking to Tom.
I ended up getting the rest of the car done and have to say it looks a superb job - many thanks again to Anne & Joe.

I know I could have had a fair bit of re-spraying done for the money (don't ask), but a few miles down the road after leaving the bodyshop and it all starts again.
After seeing how resiliant the front has been, I feel confident now in the knowledge that any 'ping' I hear, or even don't hear, should not actually be noticeable on the paintwork.

So for anyone getting a new Porsche - especially in black - and wondering about paint protection options I would seriously consider getting a complete film protection from new, especially if you're going to use the car everyday and keep it a while.
Of course like everything there are arguments for and against this, but I'm convinced now - I think !
I can also fully agree with previous posts and confirm that the whole Paintshield experience was excellent - being friendly, professional, and thorough.

I guess in due course I'll find out if it's been value for money, but at least I won't be cringing when I meet a gritter on the road now over the next few months.
Now if only I could get the wheels done !!

Glenn McMenamin

2,305 posts

269 months

Friday 9th November 2007
quotequote all
Paintshield is a very good product, and Toms service is excellent too..

I have it on my 997 RS, my only problem is, that as it doesn't roll around the edges of
the panels, this gives you 2 problems.

1. Dirt build up along this edge which can be very hard to remove, and in the case
of the leading edge of my drivers door 'near on impossible'.

2. The exposed edges where the film does not cover is now pretty chipped, this is
especially bad on the edges of the bonnet, which will mean a respray at some point, of
which kind of defeats the idea.

I use my car mainly for track, so this maybe be a more extreme case, but i would say that's supposed
to be one of the main reasons to get this stuff.

The 'other' brand you mention, rolls around the edges, which will do away with the above problems.


Either way, you are right, get it done asap, before it's not worth doing at all.


G.



Edited by Glenn McMenamin on Friday 9th November 18:54

anglebox10

Original Poster:

2,733 posts

242 months

Friday 9th November 2007
quotequote all
Fair comment Glenn.
To be honest I haven't noticed any dirt build up anywhere yet - maybe black has an advantage here !
Also no sign of chips on leading edges either, but will keep fingers crossed and stick to the roads for now.

Glenn McMenamin

2,305 posts

269 months

Saturday 10th November 2007
quotequote all
Guam said:
Thanks for the kind remarks Angelbox much appreciated.

As you know Glenn we CAN wrap panels if requested, it was discussed on another forum and that should no longer be an issue. As for dirt build up as I have previously explained agrressive tracking on a regular basis will lead to tar/rubber deposits on any car and on any edge, this is aknown issue amd will rffrct any film due to the hard nature of the track environment. As I have previously explained the right product to use under these specific circumstances is autosmart G101 which removes it (especially if used in conjunction with our magic sponge) let me make the same offer I have made several times run over to us (you are not that far) and I will show you how to do this and send you away with some. Its really a case I guess of the right materials to do the job.

The leading edge issue is not normally a problem for the vast majority of customers, never been a criticism in 3 years at Porsche GB I accept though that with a lot of hard trackwork (akin to racing virtually) it can be a problem so just ask for the edges to be wrapped (those that do NOT require panel removal). Quite a number of suppliers can do this now (probably 4-5 that come to mind) so its no big deal.

Give me a bell and take a run over.

Cheers

Tom
Hi Tom thanks for the words,

I wish i was given this option at the time to have the edges wrapped, but i don't recall it being offered confused

Yep, i know you have offered a few times to clean the edges, and thank you for it, however, as i said then, a near 2 hour drive to Grantham from Milton Keynes is not a welcoming thought every single time my car gets dirty, i'd rather not have the problem in the 1st place, as i think anybody would agree smile

I certainly wouldn't say this dirt build up is track specific, the kind of weather we are about to come into, is the worst time, as the roads will be very damp and grimey, and this is when these edges are at their worst.

I would agree, the stone chip problems are compounded by my mainly track usage of the car, it is the bonnet that is the worst for this, surely you can get access under a bonnet without having to take it off ??
Also, you must be able to wrap around a door without having to take it off, when all you have to do is just open it, to get access the inner edges confused


All the best



G.




Edited by Glenn McMenamin on Saturday 10th November 23:18

Vipergreen

340 posts

260 months

Sunday 11th November 2007
quotequote all
My new RS is due in the next week and I was thinking of the dealer offered Armourfend I think it's around £700 for PU, bonnet, mirror backs, inner wheelarches and rear arches.

How doe's this compare

steve.B

457 posts

238 months

Sunday 11th November 2007
quotequote all
I had the full front done on my 997 by Armourfend with the 3M and the bonnet was wrapped along with the doors.
Still have a little issue in places with dirt build up and have never track the car.
Found the best way to sort this is to use Q tips with a little meths

Hope it helps smile

anglebox10

Original Poster:

2,733 posts

242 months

Sunday 11th November 2007
quotequote all
Vipergreen said:
My new RS is due in the next week and I was thinking of the dealer offered Armourfend I think it's around £700 for PU, bonnet, mirror backs, inner wheelarches and rear arches.

How doe's this compare
If that's the whole bonnet then you're probably not far off.
I've found the area that takes the worst beating is the sills just ahead of the rear wheels, the rest of the sill gets pretty chipped as well.
On other 911's this area is painted with a textured underseal type finish, but not on the GT3's. The factory fitted film protection stops above the rear sill area, presumably as it wouldn't stick here and they didn't bother changing it for the GT3's.
Personally I'd look at getting the sills covered, and also the area above the factory fitted piece on the rear wheel arches.

I'm sure a lot of this hassle could be prevented with a decent pair of front 'mudflaps', but they might just spoil the look a little I suppose !!
Anyway good luck next week and enjoy the car.

Sandy

ScottL

814 posts

261 months

Monday 12th November 2007
quotequote all
There is no factory fitted film on the rear arches of a 997GT3RS.

Vital to fit some though as this area is extremely vulnerable to stone chipping.

I had my car done by Nick at AMI upon collection in September. Extremely pleased with the results. Will post some pics later to highlight the fantastic attention to detail.