Discussion
Common problem on the Elise/Exige. Try the fuse, but I would put my money on the following
A) Blows, but no hot air: The resistor has blown on the heater matrix unit. This is a weak spot because water collects and sits on the Matrix unit and corrodes the resistor
B) No Blow, Hot or Cold: Heater motor has gone, again another weak point on the Elise/Exige due to water build up.
Ether way it will be a clam off job to sort out ether problem. A dealer will charge £ 500-600. I would suggest that if one item has gone, you replace the other one at the same time.
I had both items go with in months of each other, luckily they was both done under warranty.
I would also suggest you get your radiator, hoses and connectors checked out as well at the same time because they also wear out.
A) Blows, but no hot air: The resistor has blown on the heater matrix unit. This is a weak spot because water collects and sits on the Matrix unit and corrodes the resistor
B) No Blow, Hot or Cold: Heater motor has gone, again another weak point on the Elise/Exige due to water build up.
Ether way it will be a clam off job to sort out ether problem. A dealer will charge £ 500-600. I would suggest that if one item has gone, you replace the other one at the same time.
I had both items go with in months of each other, luckily they was both done under warranty.
I would also suggest you get your radiator, hoses and connectors checked out as well at the same time because they also wear out.
How good are you with a spanner you can always buy the parts your self and replace them ,here a link on how to take the front clamshell off, and will save you alot of money
http://wiki.seloc.org/a/Remove_S2_front_clamshell
http://wiki.seloc.org/a/Remove_S2_front_clamshell
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff






