World's most annoying oil leak?...
World's most annoying oil leak?...
Author
Discussion

johnfm

Original Poster:

13,752 posts

281 months

Monday 19th November 2007
quotequote all
No, I'm not talking about the RMS. Mine is as dry as a dry thing in a desert located tent with silica gel sachets and a dehumidifier. No, I have a weep at the rear of engine. At he rear of the GT3 engine there are two small aluminium washers. One of them has a small hex-head plug screwing into the rear of the casing. The other seals the interface between the rear of the casse and the oil/coolant pipe thing at the rear of the engine. The aluminium washers have corroded, and so oil is leaking. The 10p washer sealing the bit from the case to the oil/coolant pipe thingy cannot be replaced without dropping the engine and removinf the rear beam, associated pipework, catalytic converters etc. So, about 4 hours to replace a 10p aluminium washer.

That is not good design.

Still, 9M did a cracking job on my 48k service! Thanks Colin, Robin & co!

AJAX50

418 posts

271 months

Monday 19th November 2007
quotequote all
If you can get to it, try cleaning carefully and putting some sealer or super glue round it.

johnfm

Original Poster:

13,752 posts

281 months

Monday 19th November 2007
quotequote all
I can get to it easily. You just cannot replace the seals without dropping engine and pulling bits off the back of it. I am a bit loathe to put some sealing goo on a GT3 engine - it will stop the leaks no doubt, just doesn't seem the right thing to do.

Pope

2,653 posts

278 months

Monday 19th November 2007
quotequote all
PAIN!!

Quite a common complaint, as are the coolant bung washers. On 996/986 the chain tensioner washers suffer the same issue. As you said, its a s### that the whole lot has to come off though.

you could tie it all up with a new exhaust - wouldn't be as painful (glass half full moment, sorry)

Edited by Pope on Monday 19th November 12:26