Quick seat question....

[anonymous-user]

I'm going to be swapping my drivers seat for a passenger side one. Am I right in thinking they are exactly the same i.e. same mounting points underneath, etc?

Cheers

[im]

Won't the positioning of the handle used to move the seat back-and-forth be an issue?

[Aubrey]

Also the lever to tilt the seat forward to access the cubby holes will be hard up against the centre console.

Edited by Aubrey on Thursday 31st January 11:13

[im]

Aubrey said:

Also the lever to tilt the seat forward to access the cubby hoes will be hard up against the centre console.

Actually - thats the one I meant...

[Aubrey]

Of course it was, I believe you

[anonymous-user]

Thought as much. Retrim it is then.......

[andy-w]

BagOfOldRats said:

Thought as much. Retrim it is then.......

Swap the frames....???

It would not be that hard to do...?

[spend]

Mine worked ok when I swapped them over, but really got fed up of having to lean over to tilt the seat... put them back shortly afterwards

Dave

[anonymous-user]

spend said:

Mine worked ok when I swapped them over, but really got fed up of having to lean over to tilt the seat... put them back shortly afterwards

Dave

Did the tilt handle rub against the carpet though?

[Aubrey]

The other question is, how often to you tilt the seats or use the cubby holes? I haven't used them so far and have had quite a few bits in the back. If you don't use them then it might not be an issue.

[andy-w]

Aubrey said:

The other question is, how often to you tilt the seats or use the cubby holes? I haven't used them so far and have had quite a few bits in the back. If you don't use them then it might not be an issue.

the cubby holes are a good place to mount the fusebox in one and the ecu in the other...

BTW did it arrive today???