Replacing the main beam units
Discussion
I've just got my new main beam units to replace the old cloudy ones and match up with my new Sportmotive ones 
Before I head out to the garage how do they locate? Do they just sit in the rubber "boot" from the front or do you have to remove the old units from the car and fit from the rear?
Before I head out to the garage how do they locate? Do they just sit in the rubber "boot" from the front or do you have to remove the old units from the car and fit from the rear?
Ooer... Dunno, she's still on axle stands! I've just got some aviation canopy polish to clean up the perspex covers before I finally fit them. Look like a good bit of kit so far, but I've added some black 2mm double sided tape to seal the pods to the perspex cover, just to be sure.
As for the main beam units, there are three locating lugs on the new ones but I haven't been out to the garage to figure out what they attach to and if you actually need to remove them from the car. Doesn't look like much of a job if you do but I like to know what to expect before I start.
As for the main beam units, there are three locating lugs on the new ones but I haven't been out to the garage to figure out what they attach to and if you actually need to remove them from the car. Doesn't look like much of a job if you do but I like to know what to expect before I start.
Gassing Station | Griffith | Top of Page | What's New | My Stuff