Low oil pressure bulb .

[RFC1]

The low oil pressure warning light has not worked on my 92' griff for some time, i am pretty sure its the bulb that has gone, before i try to change it ,does anyone know if it can be changed without removing the dash board? If not should i be checking anything else before condeming the bulb.?? connection to the sender seems ok.
thanks Sandy

[Johno]

I'd change the sender first to make sure it isn't that or have you checked the sensor output difference during the engine start up, otherwise it is a dash out job . .

[spend]

Johno said:

I'd change the sender first to make sure it isn't that or have you checked the sensor output difference during the engine start up, otherwise it is a dash out job . .

Just ground the wire at the switch first.

Are you confusing the switch (warning light) and sensor/sender (oil pressure gauge) Johno? The switch is just on/off and works or not

[Johno]

My choice of words was perhaps wrong, sensor meant switch . . Ground it first as you suggest. Then go for replacement bulb if necessary.

[RFC1]

Thanks gents, will try and report back, if it is the bulb and requires dash out it can wait for now!!
sandy