Measurement required chaps
Discussion
With one door fully open 2180mm but it does go wider than that as it opens so if your 2200 is wall to wall then I would think it is a non starter.
If your drive is level then I have seen people with large cars line them up, get out, then push the car in.
We could try a test fit with mine sometime.
Steve
If your drive is level then I have seen people with large cars line them up, get out, then push the car in.
We could try a test fit with mine sometime.
Steve
I'm inclined to agree with Steve on this one. That sounds pretty tight. My garage is 2700mm and that is about as tight as I'd like for 2 reasons. One is when I work on it, I always seem to have one side too close to the cabinets and can't get my hips between the car and the cabinets to get down under the car. The other is the doors opening. If I'm off center just a little, one of them touches the cabinet as it reaches the top of its swing. Don't get me wrong, 2700mm works but it isn't too roomy either.
It is an absolutely incredible car, so if you can make it work you should go for it!
Good luck,
Paul
It is an absolutely incredible car, so if you can make it work you should go for it!
Good luck,
Paul
Gassing Station | Ultima | Top of Page | What's New | My Stuff