depressed

[aquarama]

Hi all, to cut a long story short I need to get a clutch plate made, I need a 23 splines per inch centre in a rover kv6 plate if anyone knows a company that could do this could they let me know I've tried different ford plates but they don't sit in the rover flywheel or clutch cover properly I am at my whitts end.
Thanks Matt

[stevieturbo]

Helix, Superclutch, Alcon, AP no doubt there are others.

Im sure if you phone them, detailing your requirements, they will be able to assist.

[aquarama]

Stevie thanks for your response Helix can do it but there are a few probs involved I may have to go down this route but to
locate a plate will be quicker. I have a question do you know weather the centre [fly wheel side] of the 230mm driven plate from a scooby is below the clutch plate surface or weather it pretrudes above it.
Many thanks Matt