Estimate Hours For Turbo Replacement
Estimate Hours For Turbo Replacement
Author
Discussion

Iaing01

Original Poster:

421 posts

240 months

Monday 14th July 2008
quotequote all
Hi folks, bit of a long story behind this one.

My car is currently and has been in a garage for 8 weeks! I put it in to get an exhaust made for it and upon replacement they found that one of the turbo's was knackered. So i decded to have both taken off and replaced.

I'm not naming any names as the garage still has my car but today when I phoned (after being told the car might be ready!) the garage owner had a severe attitude and basically told me to let them get on with it and to stop phoning! Nice!

He told me that i had no idea of the amount of work involved in chaning the turbo's (which I'm pretty sure I do!). C

Could someone give me an idea of the work involved, hours, cost etc just for the labour. I feel like i'm going to need some ammo when I go to pick the car up.

Sorry for going on!


Adrian W

15,494 posts

257 months

Monday 14th July 2008
quotequote all
Should let people know on Nobleparts so noone else goes there, oh and with a ramp either turbo shouldnt take longer than 2 hours start to finish.

Iaing01

Original Poster:

421 posts

240 months

Monday 14th July 2008
quotequote all
Cheers Adrian, I will but I doubt anyone will use them as its a small local localish garage.


JAZ 34

568 posts

272 months

Monday 14th July 2008
quotequote all
Iain,

Which garage?

Jamie

Alpinestars

13,954 posts

273 months

Thursday 17th July 2008
quotequote all
I think Noble recommend around 10 hours for both turbos, but I am sure it's a shorter job than that. I think it depends on the bolts coming off cleanly.

Roop

6,018 posts

313 months

Thursday 17th July 2008
quotequote all
Assuming access to the turbos is simple and a similar installation to most turbocharged cars it should be very straightforward. I've had the turbo on my car removed and refitted twice in the space of a morning without problem.

As has been said, assuming it unbolts cleanly and any gaskets or such don't break or any crap fall into the turbine it's a very simple job - Noble's 10h is a lot. You could take them off, rebuild them, true them and refit in that time I reckon.

ThatPhilBrettGuy

11,810 posts

269 months

Thursday 17th July 2008
quotequote all
Roop said:
Assuming access to the turbos is simple....
Incorrect for one at least.

Roop

6,018 posts

313 months

Thursday 17th July 2008
quotequote all
ThatPhilBrettGuy said:
Roop said:
Assuming access to the turbos is simple....
Incorrect for one at least.
In that case, and assuming there's no "trick" used by garages familiar with Nobles to circumvent the problem, then the garage may well be disassembling half your car to change one of the blowers which could explain the delay.

Perhaps they can't work out how it goes together again...? confused

NobleGuy

7,133 posts

244 months

Thursday 17th July 2008
quotequote all
Roop said:
Perhaps they can't work out how it goes together again...? confused
hehe

saucyboy

1,865 posts

258 months

Thursday 17th July 2008
quotequote all
I'm no expert and I haven't changed the turbos yet, but i have had the whole exhaust off twice in my little garage and it didn't take long.

james