Slightly unusual Haynes Manuals...
Slightly unusual Haynes Manuals...
Author
Discussion

Dibble

Original Poster:

13,292 posts

271 months

Saturday 26th July 2008
quotequote all
Here...

ceebmoj

1,899 posts

292 months

Saturday 26th July 2008
quotequote all
Right so they just need to bring a concord one out as long as i get a mate to help with the 5 spanner jobs it will be fine and super sonic transport is hear again.

blake

MonkeyHanger

9,267 posts

273 months

Saturday 26th July 2008
quotequote all
I wonder if they'll do one for a Vulcan?

Every 3rd page you'll have to stump up more money for the project to continue whistle

Clammy

2,352 posts

230 months

Saturday 26th July 2008
quotequote all

Sciroccology

29,908 posts

261 months

Saturday 26th July 2008
quotequote all
Clammy said:
Even handier

Edited by Sciroccology on Saturday 26th July 20:40

Killer2005

20,649 posts

259 months

Ledaig

1,811 posts

293 months

Saturday 26th July 2008
quotequote all
ceebmoj said:
Right so they just need to bring a concord one out as long as i get a mate to help with the 5 spanner jobs it will be fine and super sonic transport is hear again.

blake
Quite a fitting typowink

Uncle Fester

3,114 posts

239 months

Saturday 26th July 2008
quotequote all
Good job we didn’t have those manuals in the war. We would all be speaking German.

I thought they were bad when I discovered the reason my engine had blown up was they had published the wrong settings for the ignition timing.

I was talking to a guy who ran a tuning business specialising in the model I had. He explained that there had been two types of ignition unit fitted and they had two different settings. They advanced differently. So when I strobed it I was at the wrong rev's It would run fine at low rev's but at high rev's in use it would be way over advanced. But Haynes had only given the one setting for all ignition units.

That was nothing, the guy said. They spent a page explaining how to change the small end roller bearings, and there weren’t any, it was a plain bearing. Perhaps there had been two types I asked?

“Unlikely”, he said. “I designed the engine and was Director of engineering development until the factory closed. I would have had to sign off any changes to production”
yikes