looking for a wiring diagram for '95 chimaera
Discussion
2nd of juli 2007 brought my chim to dealer for new camshaft. One year later!! I have more power but after the first ride (with a smile), the motor runs so bad it hurts. Guess that the computer takes so many faultcodes that it stops. There must be a problem with the wiring and the book of Steve is not very clear. Any ideas???
Jimmy, Have you got a few more details like which engine you have?, what camshaft you have fitted?, did the problem start with the camshaft change?
Have you checked all the ignition components? and you say the think the ecu is full of faults have you plugged it into a fault code reader to find them out, they can be cleared by simply unplugging the ecu for 30 seconds and plugging back in again although they will return if somthing is wrong. The wiring diagram in the steves book is the same as the one in the Haynes Range Rover manual and its not bad if you study it for while.
Have you checked all the ignition components? and you say the think the ecu is full of faults have you plugged it into a fault code reader to find them out, they can be cleared by simply unplugging the ecu for 30 seconds and plugging back in again although they will return if somthing is wrong. The wiring diagram in the steves book is the same as the one in the Haynes Range Rover manual and its not bad if you study it for while.
I think there are few people on here that hire them out but not sure about overseas if you take it to your local landrover specialist they should be able to help. Its possible that the cam you have is going to make the car run like that, but I won't know until I know which one it is, best to find that out first.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff