Tunnel and Dash
Tunnel and Dash
Author
Discussion

BRGS2

Original Poster:

2,829 posts

271 months

Thursday 18th September 2003
quotequote all
I am (finally) getting round to fitting my carpets this weekend - I note from the bible (and a cursory glance at the tunnel) that this is a one piece unit with the Dash on my S2.

I am slightly wary of unhooking the dash fully - will the tunnel be able to be lifted sufficiently to carpet underneath without fully removing it (and thus the dsh too) from the car?

bridgdav

4,805 posts

271 months

Thursday 18th September 2003
quotequote all
Hi Tim

Removing the tunnel was pretty easy on my S3. Just remove the two screws at the rear, lift up and pull towards you (no nob gags) I didn't remove it fully as I would have to disconnect all the switches. With the tunnel lifted you have access to almost all the carpeted areas.

Hope this helps.
Dave

lurch

98 posts

274 months

Thursday 18th September 2003
quotequote all
BRGS2 said:
I am (finally) getting round to fitting my carpets this weekend - I note from the bible (and a cursory glance at the tunnel) that this is a one piece unit with the Dash on my S2.


Have you a bought a carpet set measured to fit, or have you bought a roll of carpet and doing it yourself?

What colour are your carpets, same as the originals? I have a BRG S3 and if I can match the carpet (pale green) will only need to do the drivers side. Yours might be the same colour.

Cheers
sam

GreenV8S

30,999 posts

307 months

Thursday 18th September 2003
quotequote all
But an S3 has a separate tunnel cover whereas the S2 has that beautiful swoopy one-piece tunnel/dash. I don't know how much access you can get, I guess your easiest option is to have a go but don't force it and be prepared to stop.

kev s3

212 posts

287 months

Saturday 20th September 2003
quotequote all
hi tim, was looking for a carpet set myself soon, did you get them from a dealer or are you making them up?
cheers

BRGS2

Original Poster:

2,829 posts

271 months

Monday 22nd September 2003
quotequote all
kev s3 said:
hi tim, was looking for a carpet set myself soon, did you get them from a dealer or are you making them up?
cheers


Kev - just made it up.

as you see from my other post though it took ages and i can barely type cos my fingers are so sore....

I planned to remove the sections and use tham as templates but the footwells had rotted so I had to remove them in about 50,000 seperate pieces....

had to cut a few corners but the result is good