Was Nick at brans
Author
Discussion

TVRleigh_BBWR

Original Poster:

6,553 posts

242 months

Monday 8th September 2008
quotequote all
I got a logger, as per this year's reg's but could not find Nick for him to set-up my data card.

450Nick

4,027 posts

241 months

Monday 8th September 2008
quotequote all
Hi Leigh, yeah I was there! I saw your car on the track but didn't see it or you in the pits - were you in the garages with Green Star? Sorry I forgot to reply to your call the other day, give me a call tomorrow after 5 and I'll be free to go through it with you no problem.

TVRleigh_BBWR

Original Poster:

6,553 posts

242 months

Monday 8th September 2008
quotequote all
450Nick said:
Hi Leigh, yeah I was there! I saw your car on the track but didn't see it or you in the pits - were you in the garages with Green Star? Sorry I forgot to reply to your call the other day, give me a call tomorrow after 5 and I'll be free to go through it with you no problem.
Well I need book garage 8 next to Keith and Tim, but one of the MG guys stole it. so hard to go in Garage 30 next to Greenstar.

I did ask if you was about but no one knew, was a very busy sorting the car. anyway.

don't think any will complain about my power anyway, esp the low fuel pressure in 1st race due to a leak, then an ignition problem in the 2nd. so would not go above 3500 RPM.

main problem I had is the DL1 is makeing the .run files as directorys and the software is not reading them.

will give you a call tomorrow if thats ok
Leigh

450Nick

4,027 posts

241 months

Monday 8th September 2008
quotequote all
Hmm sounds a little odd... Does it have the latest firmware on? Give me a call tomorrow and we can go though it and hopefully find the source of the problem. You may not have any problems with power but you can learn quite a lot from the data. Especially as a novice, you can view your data against someone like Mickey and see where your lines differ - or braking points, cornering speeds etc etc.

Edited by 450Nick on Monday 8th September 23:00

TVRleigh_BBWR

Original Poster:

6,553 posts

242 months

Monday 8th September 2008
quotequote all
Only bought the unit last week, so would have thought it's got the lastest firmware, it could be a old unit, as it came with a dash, and I could not get the 5v out from the dash either.

Also bought the ECU link but could not get that to work either.

how do you check the version.

will call you tomorrow about 7 if that's ok.