rd350 restricted
Author
Discussion

SplatSpeed

Original Poster:

7,491 posts

282 months

Tuesday 16th September 2008
quotequote all
OK guys how do i restrict one of theese for the wifey

Thanks

podman

9,086 posts

271 months

Tuesday 16th September 2008
quotequote all
To 33BHP?..Strange choice of bike to restrict, I guess the easiest way would be to modify the throttle slides to they dont lift as much.


kiwi_uk

279 posts

241 months

Tuesday 16th September 2008
quotequote all
http://www.batmotorcycles.co.uk/33bhp.asp

These guys do a restriction kit for the RD. Not sure how it's done though but might be useful talking to them.

mitzy

13,858 posts

228 months

Tuesday 16th September 2008
quotequote all
kiwi_uk said:
http://www.batmotorcycles.co.uk/33bhp.asp

These guys do a restriction kit for the RD. Not sure how it's done though but might be useful talking to them.
I would try looking around BAT Motorcycles are expensive for bike and for mods.

What sort of area are you ?

SplatSpeed

Original Poster:

7,491 posts

282 months

Tuesday 16th September 2008
quotequote all
mitzy said:
kiwi_uk said:
http://www.batmotorcycles.co.uk/33bhp.asp

These guys do a restriction kit for the RD. Not sure how it's done though but might be useful talking to them.
I would try looking around BAT Motorcycles are expensive for bike and for mods.

What sort of area are you ?
thanks south coast

Carl-H

947 posts

237 months

Tuesday 16th September 2008
quotequote all
Don't buy an FI international kit for £200 odd pound. FI international will lead you to believe you need their kits to be legal. The law says the bike has to bee 33bhp but nothing about certificates. The best way is get it dyno's and put a pin in the throttle at around 30hp. Will cost £30 and a readout should be enough proof for insurance (although most don't ask). Also, the police have to prove the bike is over 33bhp. You don't have to prove anything to them.

odyssey2200

18,650 posts

240 months

Tuesday 16th September 2008
quotequote all
IIRC there is a plate (with a smaller hole)that goes between the reed valve block and the inlet to act as a restriction.