Do bikes suffer more from lumpy idle/fuelling vs cars?
Discussion
Presume it's carbs? As Steve said blanacing could well help, but if you're running an atermarket pipe or airfilters has it been rejetted to match them? If not it could be running lean all across the rev range which could cause the low rev lumpiness. Depending on the mileage you could have some worn components. I changed my emulsion tubes a couple of years back and got a smoother idle, more low down torque, and a big decrease in fuel consumption.
Hi Simon -
Check that the plugs aren't fouled up for a start. The idle speed is a little lower than I have my Hornet set to - what's the owner's/Haynes manual say?
If you fancy balancing the carbs, I have a synchronometer you can use from the days that I needed it for some Weber carbs.
S
Check that the plugs aren't fouled up for a start. The idle speed is a little lower than I have my Hornet set to - what's the owner's/Haynes manual say?
If you fancy balancing the carbs, I have a synchronometer you can use from the days that I needed it for some Weber carbs.
S
Agree with all the points posted. My SV and Falco both should idle around 1350 rpm and I'd note that as you improve the idle smoothness by balancing the air flow and therefore the power generated on each cylinder firing, you will pick idle speed as a natural consequence. This may be your problem. In terms of lean running, partly it may be due to an aftermarket can, but also it tends to be the case that manufacturers often fit an undersized idle jet in carbs to pass the emissions tests they're subject to. Injected bikes tend to be mapped lean for the same reasons. Hesitancy as you roll on the throttle is a common problem resulting from such lean fueling. If your bike hasn't been serviced for a bit then new plugs and a carb/tb sync will likely be part of this and may be all that's required to sort things out. Start with getting the bike running to the manufacturers specs before you look at anything else more complicated. If you're comfortable looking at things yourself, I'd recommend a Morgan Carbtune as the tool to help balance things up.
Cheers,
Steve.
Cheers,
Steve.
StevRS said:
Get yourself a haynes manual and have a go - they're simple things, really!
I do want to learn some of this stuff. First I have to get tools and the manual, as you say. I'm hoping to get a new bike next year at which point I may well keep my current one and have a go at stripping it down and learning the ropes. Will be more fun in warmer weather too.Gassing Station | Biker Banter | Top of Page | What's New | My Stuff




