Trouble changing gear.
Trouble changing gear.
Author
Discussion

PapaBear

Original Poster:

14,233 posts

225 months

Saturday 25th October 2008
quotequote all

I'm having trouble going up through the gears. No problems going down the gears only up.

It can take a couple of attempts to get it in gear. Only happened once in a while but now I'm noticing it becoming more frequent.

Any suggestions??


Thanks


untruth

2,834 posts

220 months

Saturday 25th October 2008
quotequote all
Might help if you say which bike!

PapaBear

Original Poster:

14,233 posts

225 months

Saturday 25th October 2008
quotequote all
Doh!'

It's a ZXR750 H1 '89

Hooli

32,278 posts

231 months

Saturday 25th October 2008
quotequote all
how old is the oil?
is the chain tension right?
is the linkage worn so its not fully articulting the selector forks?

Momentofmadness

2,371 posts

272 months

Saturday 25th October 2008
quotequote all
^^^ what he said.

It's always worth stripping, cleaning and relubing the gearchange pivot points too.

Hooli

32,278 posts

231 months

Saturday 25th October 2008
quotequote all
Momentofmadness said:
It's always worth stripping, cleaning and relubing the gearchange pivot points too.
oh good point & if they are cruddy then do the same for the brake pedal as it'll be as bad.

Chilli

17,320 posts

267 months

Saturday 25th October 2008
quotequote all
Could the footpeg need adjusting?

PapaBear

Original Poster:

14,233 posts

225 months

Saturday 25th October 2008
quotequote all
Chilli said:
Could the footpeg need adjusting?
The gear change problem has been there for a few weeks, however today I noticed the footpeg was quite loose. After tightening I took it for a spin and I must admit I noticed the gear problem was more frequent.

Hooli

32,278 posts

231 months

Saturday 25th October 2008
quotequote all
if its in every gear then i'd expect its exterior to the gearbox, so linkage etc. the way boxes are built internal faults tend to affect two gears at a time, as generally two clusters share a selector fork & shaft.

Roger McLittriss

493 posts

285 months

Saturday 25th October 2008
quotequote all
Could be the centring spring on the selector drum. Had a couple of those snap down the decades.

RizzoTheRat

29,170 posts

223 months

Sunday 26th October 2008
quotequote all
I had some trouble ages back where I found the gear selection really stiff and for the first few changes of the ride the lever wouldn't drop back to the central position itself. Found the problem was lack of maintenance, quick clean and some grease on the linkage it's as smooth as ever...well I say smooth...Ride magazine did once describe the TDM gearbox as "clunkier than a paddle steamer on dry land" rolleyes