Yamaha TRX 850
Discussion
Hi Guys
I've been thinking about getting myself a bike, and i really like the TRX 850 twin.
I've seen one which looks nice for sale, but it has around 40.000 miles on the clock.
I am thinking that is a bit too much for a bike? Any experiences?
Also if any of you owns one of these or have tried on i'd like to hear your thoughts on it?
Kind regards
Dennis

I've been thinking about getting myself a bike, and i really like the TRX 850 twin.
I've seen one which looks nice for sale, but it has around 40.000 miles on the clock.
I am thinking that is a bit too much for a bike? Any experiences?
Also if any of you owns one of these or have tried on i'd like to hear your thoughts on it?
Kind regards
Dennis

There's a fairly active owners forum who whould be able to answer most questions
http://trx850.motomaniac.net/forum/
Mechanically they're pretty bulletproof, same engine as the Mk2 TDM and I know of people who've run them to over 100k miles. They all use oil though, and if it gets too low you can have some serious problems, so check it's been well looked after.
http://trx850.motomaniac.net/forum/
Mechanically they're pretty bulletproof, same engine as the Mk2 TDM and I know of people who've run them to over 100k miles. They all use oil though, and if it gets too low you can have some serious problems, so check it's been well looked after.
Edited by RizzoTheRat on Tuesday 28th October 20:57
My CBR600 has over 60,000 miles on the clock and the engine is sweet like you wouldn't believe. It's the rest of the bike that takes the battering, as long as the engine is regularly serviced I'd not worry about it. It's suspension, bushes, chain, sprockets, etc. that get knackered with age.
Also the front brake discs can be getting on for needing replacement (pads obviously get done more frequently, but discs cost a lot more to replace in general) and that's often a £500 job at a main dealer (cheaper if you do it yourself, but the discs are often over £200 a set).
As long as the servicing is up to date, then the engine should be OK - but I'd only buy it if the other bits had been attended to as well - if there's recent service history of new sprockets, chain, and suspension overhauls then it should be absolutely fine. You only clock up mileages like this by commuting on it, so the bike is likely to be in better mechanical condition than a garage queen or track s
g, but commuting wears out suspension and that's what I'd be most concerned about.
Also the front brake discs can be getting on for needing replacement (pads obviously get done more frequently, but discs cost a lot more to replace in general) and that's often a £500 job at a main dealer (cheaper if you do it yourself, but the discs are often over £200 a set).
As long as the servicing is up to date, then the engine should be OK - but I'd only buy it if the other bits had been attended to as well - if there's recent service history of new sprockets, chain, and suspension overhauls then it should be absolutely fine. You only clock up mileages like this by commuting on it, so the bike is likely to be in better mechanical condition than a garage queen or track s
g, but commuting wears out suspension and that's what I'd be most concerned about.i had one for a few years, it was a cracking bike just put some blue spot calipers on it as the stock ones are dangerous....they do use oil so keep an eye on the level you will need to top it up about every 500miles ... mine used 1 liter every 1000miles Yamaha uk said that was normal as long as it stayed at that rate not any worse
2nd gear is a week point so check it doesnt jump out of gear under load, also the clutches are week too as first gear is fairly tall
my old baby had a bit of head work,uprated clutch and race exhausts plus ALOT more stuff to much to list... it was a real sleeper, yeah i'd have another one for sure

2nd gear is a week point so check it doesnt jump out of gear under load, also the clutches are week too as first gear is fairly tall
my old baby had a bit of head work,uprated clutch and race exhausts plus ALOT more stuff to much to list... it was a real sleeper, yeah i'd have another one for sure

Ported and flowed or different cams? Apparently with the right cams and set of FCR carbs you should be able to get 100bhp out of them, which doesn't sound a lot but it's very torquey and has a very wide power band.
If you want to do some serious fettling you can put the TDM 900 top end on them for a bit more grunt with the added benefit that the ceramic bores stop them drinking oil.
If you want to do some serious fettling you can put the TDM 900 top end on them for a bit more grunt with the added benefit that the ceramic bores stop them drinking oil.
Gassing Station | Biker Banter | Top of Page | What's New | My Stuff



