HID headlamp conversion on Chim
HID headlamp conversion on Chim
Author
Discussion

Teetertank

Original Poster:

358 posts

218 months

Friday 5th December 2008
quotequote all
Have many people here converted to HIDs?

Seems to be a few Grifs with conversions done, but not so many Chims.

I need to replace the headlamp reflectors due to rust, so thought while I’m at it, it would be a good opportunity to upgrade the lights.

Will this involve removing the head lamp cowlings and glass, or is there an access hatch under the front wheel arch?

If anyone has done this, how involved is it on a Chimaera, do you need to glue the lamp holders into the reflectors etc? Seems we need H4 kits, will they work for both high and low beam? Thanks in advance.


scotty_d

6,795 posts

225 months

Friday 5th December 2008
quotequote all
Hi i have just ordered these my x-mas presentbiggrin they are very easy to fit i have allready fitted a set to my every day car.

If you want hi/low beam you need bi xeon and it is just a case of plug and play very straight forward.
i went for 6000k as these are most legal common ones.

You get access under the front wheel arch you will see it when you take your wheel off.

Scotty

Edited by scotty_d on Friday 5th December 11:35

drew.h

526 posts

220 months

Friday 5th December 2008
quotequote all
With the HIDs you get the bulb bit that should replace your H4 without any modification, then there is the ballast (box of electronics) you need to mount somewhere. Ballast normal connects to the old H4s connector, so very little wiring to do.

Problem with H4s is the duel beam. Two options appear to be a halogen bulb for the main or a shroud that moves when the main beam is selected. The problem with the shrouds is they have a tendency to fail (on the cheap ones anyway), leaving the headlight on main beam.

Buy some Osram night breakers instead.

Teetertank

Original Poster:

358 posts

218 months

Friday 5th December 2008
quotequote all
scotty_d said:
Hi i have just ordered these my x-mas presentbiggrin they are very easy to fit i have allready fitted a set to my every day car.

If you want hi/low beam you need bi xeon and it is just a case of plug and play very straight forward.
i went for 6000k as these are most legal common ones.

You get access under the front wheel arch you will see it when you take your wheel off.

Scotty

Edited by scotty_d on Friday 5th December 11:35
Thanks, so no requirement to glue any lamp holders etc in, obviously other than mounting the ballasts?

Did you have any probs with Hi/lo switching?

spend

12,581 posts

282 months

Friday 5th December 2008
quotequote all
I did it a few years ago, but it was one of the reasons I wanted to convert to speed12 lights using the Hella light units (as per factory HID installs). I also thought the single HID hi/lo solutions seemed a bit of a contrived compromise?

Meatball

1,638 posts

241 months

Friday 5th December 2008
quotequote all
I had hids on mine but they kept blowing fuses, ive gone back to better h4 bulbs and no problems since.

spend

12,581 posts

282 months

Friday 5th December 2008
quotequote all
I warned folks about upgrading the wiring just for the ballasts kick start a while ago, most said it wasn't necessary wink

David Beer

3,982 posts

298 months

Saturday 6th December 2008
quotequote all
scotty_d said:
Hi i have just ordered these my x-mas presentbiggrin they are very easy to fit i have allready fitted a set to my every day car.

If you want hi/low beam you need bi xeon and it is just a case of plug and play very straight forward.
i went for 6000k as these are most legal common ones.

You get access under the front wheel arch you will see it when you take your wheel off.

Scotty

Edited by scotty_d on Friday 5th December 11:35

gordonsalive

446 posts

218 months

Thursday 11th December 2008
quotequote all
Did an HID conversion a few months back. Beam pattern is really all over the place so probably gonna go back to standard with Phillips X-treme or similar. Also if you have an older Chim there is no access hatch in the wheel arch, it all has to be done through the grill.

spend

12,581 posts

282 months

Thursday 11th December 2008
quotequote all
gordonsalive said:
..if you have an older Chim there is no access hatch in the wheel arch, it all has to be done through the grill...
Its quite easy to chop out the cross stays, then you can get head & shoulders into the mouth, which makes working in there a lot easier.

My bonnet became less stable at the front, so I just replaced the stays with some alloy strips behind the grill which can be unscrewed when necessary wink

scotty_d

6,795 posts

225 months

Thursday 11th December 2008
quotequote all
spend said:
I warned folks about upgrading the wiring just for the ballasts kick start a while ago, most said it wasn't necessary wink
Make sure you go for Slow start with no inrush current. extends bulb life and does not blow fuse,s wink

Edited by scotty_d on Thursday 11th December 18:46

crispian22

982 posts

223 months

Saturday 13th December 2008
quotequote all
had hid's on my chim for about 4 months now,ran a seperate supply in for the ballast pack/controller and never had a prob with them,you can actually drive at night now.... which is nice!biggrin

Meatball

1,638 posts

241 months

Saturday 13th December 2008
quotequote all
Meatball said:
I had hids on mine but they kept blowing fuses, ive gone back to better h4 bulbs and no problems since.
I thought i should up date my post as ive now found out the reason i was blowing fuses. Hidden under the boot carpet the number plate light conections were loose and shorting against each other.

Not what you want next to the fuel tank yikes

Anyway nothing to do with the HID`s they will now go back on when i get around to it.driving

drew.h

526 posts

220 months

Tuesday 23rd December 2008
quotequote all
I remembered this topic when I found this:

Youtube illegal HID video

David Beer

3,982 posts

298 months

Sunday 4th January 2009
quotequote all
23rd Dec no response from the PHers ?? Head,sand, bury, numbsculls !!!

spend

12,581 posts

282 months

Sunday 4th January 2009
quotequote all
[Vic]You just wouldn't let it lie, would you![/Vic]

Meatball

1,638 posts

241 months

Sunday 4th January 2009
quotequote all
spend][Vic said:
You just wouldn't let it lie, would you![/Vic]
laugh

David Beer

3,982 posts

298 months

Sunday 4th January 2009
quotequote all
I know sad ain't it, speeding outside schools, wrong way down one ways, mobile phones. Go on dave give your car to vosa, they banned lorry drivers (and everyone) from having sat nav screens in line of sight, a bit late for the family of the kid! Only a few interested anyway, good old PH.

spend

12,581 posts

282 months

Sunday 4th January 2009
quotequote all
David Beer said:
I know sad ain't it, speeding outside schools, wrong way down one ways, mobile phones. Go on dave give your car to vosa, they banned lorry drivers (and everyone) from having sat nav screens in line of sight, a bit late for the family of the kid! Only a few interested anyway, good old PH.
Yes David 'Nanny State' regulation is the perfect excuse for the moronic driver to insist he behaves 'within the rules'! Get, and use, some common sense FFS wink

Do you realize this 'holier than thou' attitude makes you look a complete plonker if you just happen to break the rules in anyway? ... Like using indicators with no e-marks yikes You must be one of the few to have stepped on the moon judging by the size of your high horse rofl

David Beer

3,982 posts

298 months

Sunday 4th January 2009
quotequote all
You win! Happy
new
year
to
all
!.

Edited by David Beer on Sunday 4th January 21:08