TV's packed up, does anyone repair crt tv's anymore?
TV's packed up, does anyone repair crt tv's anymore?
Author
Discussion

69 coupe

Original Poster:

2,459 posts

240 months

Monday 15th December 2008
quotequote all
Anyone know of a good TV repairman, N-NW London area.

My lovely 2003 100hrz 32" philips pw9617 seems to have given up the ghost!

Switched tv off by power switch last night as normal,this morning I noticed that the power led was flashing instead of solid.
Tried switching on, could hear relays trying to energise power to system, tv powered back off to flashing red led.

I left tv plugged out for couple of hours at mains, replugged in led went to normal solid then powered up to picture which worked fine but now no sound at all.
Tried various resets but no sound from any source, eventually after approx 5mins tv powered itself off and went back to red flashing LED.

Obviously something wrong, searched Internet for a good few hours looking for service manuals but the only one I can find is corrupt.
Rang Philps but they reckon beyond economical repair, this looks like the case as there seems to be no TV repairers around anymore.
Are we really that much of a throwaway society.

Should I just bite the bullet & get a flat screen, to be honest the picture on my crt tv is far superior to the majority of flat panels I've seen in standard definition tv.
It just seems such a waste to bin it.

Edited by 69 coupe on Monday 15th December 15:18

loafer123

16,708 posts

244 months

Monday 15th December 2008
quotequote all
http://www.yell.com/ucs/UcsSearchAction.do?ssm=0&a...

I'd go for the ones without websites and operating out of small secondary shops if I were you.

Best service, cheapest too.

Parrot of Doom

23,075 posts

263 months

Monday 15th December 2008
quotequote all
If the engineer can get a circuit diagram then it's repairable.

10 Pence Short

32,880 posts

246 months

Monday 15th December 2008
quotequote all
The main power unit of my half decent Sony CRT went a couple of years back. Cost me £92 to repair.

Kieran XJR

5,987 posts

242 months

Monday 15th December 2008
quotequote all
It doesn't seem to be economically viable to repair electronic products these days. You could probably buy the same set again second hand on ebay for less than it would cost to fix.

ofcorsa

3,546 posts

272 months

Monday 15th December 2008
quotequote all
our panasonic Main power unit went, few years ago, Quoted £150 to fix,

Roo.

11,504 posts

236 months

Monday 15th December 2008
quotequote all
My Panansonic has, apparently, got a dry joint in the power circuit which causes noises through one of the speakers sometimes.

Thought about getting it fixed but will probably just replace the whole thing when it gives up eventually for a new flat screen for not a lot more money than fixing it.

tonyvid

9,889 posts

272 months

Monday 15th December 2008
quotequote all
I used to use a company in Reading for spare TV bits...
Willow Vale Electronics Ltd
11 Arkwright Road
Reading
Berkshire
RG2 0LU

Tel: +44 (0) 118 986 0158
Fax: +44 (0) 118 986 7188


Pigeon might be able to point you in the correct direction for fault finding.

69 coupe

Original Poster:

2,459 posts

240 months

Monday 15th December 2008
quotequote all
Rang a few TV repairers, most didn't pick up the phone, I spoke to one knowledgeable guy who thought it was not worth the effort.

May try a few more but looks like a flat screen is on the cards, trouble is 'money's too tight to mention' smile

Cheapish sub £400 37" LCD recommendations welcome.

tonyvid

9,889 posts

272 months

Monday 15th December 2008
quotequote all
69 coupe said:
Rang a few TV repairers, most didn't pick up the phone, I spoke to one knowledgeable guy who thought it was not worth the effort.

May try a few more but looks like a flat screen is on the cards, trouble is 'money's too tight to mention' smile

Cheapish sub £400 37" LCD recommendations welcome.
You won't be happy though, cheap LCDs will be nono

was8v

2,013 posts

224 months

Monday 15th December 2008
quotequote all
tonyvid said:
Pigeon might be able to point you in the correct direction for fault finding.
Don't open it up if you don't know what you are doing. Those HV caps can do you some damage if charged.

Vagabond

380 posts

225 months

Monday 15th December 2008
quotequote all
Sounds like a strange request, but power the telly on, and give it a few bangs/rock it and bump it on its stand, and see whether it runs okay between bangs (I dont mean massive bashes here, just a good bump)

It is often a dry joint on the circuit board if the problem is intermittent, the above test will indicate that and you can then look at getting someone to remove the circuit board and resolder it (or you could always do it with a £10 soldering iron and a good eye)

THX138

483 posts

222 months

Monday 15th December 2008
quotequote all
69 coupe said:
Anyone know of a good TV repairman, N-NW London area.

My lovely 2003 100hrz 32" philips pw9617 seems to have given up the ghost!

Switched tv off by power switch last night as normal,this morning I noticed that the power led was flashing instead of solid.
Tried switching on, could hear relays trying to energise power to system, tv powered back off to flashing red led.

I left tv plugged out for couple of hours at mains, replugged in led went to normal solid then powered up to picture which worked fine but now no sound at all.
Tried various resets but no sound from any source, eventually after approx 5mins tv powered itself off and went back to red flashing LED.

Obviously something wrong, searched Internet for a good few hours looking for service manuals but the only one I can find is corrupt.
Rang Philps but they reckon beyond economical repair, this looks like the case as there seems to be no TV repairers around anymore.
Are we really that much of a throwaway society.

Should I just bite the bullet & get a flat screen, to be honest the picture on my crt tv is far superior to the majority of flat panels I've seen in standard definition tv.
It just seems such a waste to bin it.

Edited by 69 coupe on Monday 15th December 15:18
Try these people

'Armstrong Video Services'
32a Blackhorse Lane, London, E17 6HJ 020 8523 0023

Useful guys

Simpo Two

92,708 posts

294 months

Monday 15th December 2008
quotequote all
69 coupe said:
Rang Philps but they reckon beyond economical repair
EFA: 'Rang Philips but they wanted me to buy a new Philips...'

69 coupe

Original Poster:

2,459 posts

240 months

Monday 15th December 2008
quotequote all
Took the back off the TV, discharged the tube smile
Removed one of the power supply circuit boards can't find any dry joints, have found a cluster of resistors that have made the circuit board look more burnt.
Going to get a multimeter tomorrow and check some resistance values, don't know enough about testing circuits though frown
will stick to a 14" portable until the New Year.

I would like a top of the range LCD but my costly top of the range Philips packed up and is now worth Muwahhhh crysmile

I'll try for a sub £400 in 2009

69 coupe

Original Poster:

2,459 posts

240 months

Monday 15th December 2008
quotequote all
Yeeeeeeeeeehaaaaaaaaaaaaa shootshootshootsmokinbiggrin

My TV's working again smile
Took the back off as in previous post, reseated the connections on the circuit boards.smash
TV's being running fine for approx 30mins bounce
I'll leave the cover off for a day or two, just in case.
Saves me buying a substandard LCD TV biggrin

Hyperion

16,952 posts

229 months

Monday 15th December 2008
quotequote all
Switch mode power supplies can suffer from dried out capacitors. If it goes again it might be worth a trip to Maplin and replace all of them in the PSU.

TheEnd

15,370 posts

217 months

Monday 15th December 2008
quotequote all
69 coupe said:
I'll leave the cover off for a day or two, just in case.
just remember CRT's run on crazy voltages, so make sure nothing will get near it

tonyvid

9,889 posts

272 months

Tuesday 16th December 2008
quotequote all
woohoo
Fettlers 1 Philips 0


TheEnd said:
69 coupe said:
I'll leave the cover off for a day or two, just in case.
just remember CRT's run on crazy voltages, so make sure nothing will get near it
I hope you don't have a pet on the loose!

69 coupe

Original Poster:

2,459 posts

240 months

Tuesday 16th December 2008
quotequote all
tonyvid said:
woohoo
Fettlers 1 Philips 0


TheEnd said:
69 coupe said:
I'll leave the cover off for a day or two, just in case.
just remember CRT's run on crazy voltages, so make sure nothing will get near it
I hope you don't have a pet on the loose!
thumbup I've had years of fettler training, used to take the back of lots of TV's in the 70's my dad bought home from god knows where!

We used to sit the tv on the dinner table and swap loads of valves out without any clue to what we were doing, the replacement valves all collected from previous secondhand TV's that we failed to repair.

We got plenty of jolts from volts though yikeswobble
Happy days. cloud9

Philips TV is still work fine today, one saved from the skip my dad will be proud smile